Luggage Boxes
Author
Discussion

Builder

Original Poster:

1,225 posts

271 months

Friday 17th August 2007
quotequote all
Decided to rubber-line the luggage boxes...


Steve_D

13,802 posts

287 months

Saturday 18th August 2007
quotequote all
What? no carpet?

Steve

andygtt

8,345 posts

293 months

Saturday 18th August 2007
quotequote all
Ahh rubber felish side pods.

Builder

Original Poster:

1,225 posts

271 months

Saturday 18th August 2007
quotequote all
Steve_D said:
What? no carpet?

Steve
Considered carpet, but thought stuff would stick in it over time...like the carpet in the boot. Impossible to get all the little pieces out.

Builder

Original Poster:

1,225 posts

271 months

Saturday 18th August 2007
quotequote all
andygtt said:
Ahh rubber felish side pods.
And so much use for the remaining strips.

San Diego GTR

469 posts

236 months

Saturday 18th August 2007
quotequote all
Good idea Scott. Can someone comment on how dark it is inside the luggage compartments? I was thinking of adding a light as it seems that once you seal it up it will be tough to see things inside, especially with black as the background.
Paul

Steve_D

13,802 posts

287 months

Saturday 18th August 2007
quotequote all
San Diego GTR said:
Good idea Scott. Can someone comment on how dark it is inside the luggage compartments? I was thinking of adding a light as it seems that once you seal it up it will be tough to see things inside, especially with black as the background.
Paul
If you are in the car you cannot easily see inside so you just find things by feel. If you are outside the car or have the door open then there is normally enough light.

Steve

Builder

Original Poster:

1,225 posts

271 months

Sunday 19th August 2007
quotequote all
Oh, yes. It's dark. It's really hard to see the throttle cable. Pictures later...

Builder

Original Poster:

1,225 posts

271 months

Sunday 19th August 2007
quotequote all
Some photos...



Notice the bracket on the left behind the heater valve. It's got a hole on the vertical face for the round bit on the side of the valve. Anchored the top hose in with a P-clip. 30mm-wide strips of blue hose wraps around the two heater hoses to keep them still. The strip was cut just short enough that the ends don't quite reach each other when zip-tied into position.



At the edges where the hoses exit the bracket, they are rounded slightly so as not to crease the hoses.

Edited by Builder on Sunday 19th August 04:56

Steve_D

13,802 posts

287 months

Sunday 19th August 2007
quotequote all
Scott
Off topic. In your top pic you have used cable ties around some blue padding to secure your hoses in place. You need to slide the tie around so that the ratchet part is either above or below the hoses and out of the way. No matter how well you cut back the end of the tie they can give you a nasty cut when 'feeling for something in the dark'. Ask me how I know.

Steve

GTRCLIVE

4,193 posts

312 months

Sunday 19th August 2007
quotequote all
Don't feel around in the Dark fitt some Interia lights in there I did, at least you can find stuff in the dead of night when stuck at the side of the road....

Builder

Original Poster:

1,225 posts

271 months

Sunday 19th August 2007
quotequote all
Steve, that's good advice. I have already done the "wrist test". The ties are there should I have a crash. I can slice my wrist without releasing my harness.

Clive, the LED lights are in stock and will have a separate illuminated switch on each sill for control. Power will come from a non-keyed circuit.