indicator relay
indicator relay
Author
Discussion

highflyer

Original Poster:

1,901 posts

255 months

Sunday 11th May 2008
quotequote all
I would like to source a replacement flasher relay, can anybody tell me what they are from please, it is a small round shiny one with a 2 pin plug.
Thanks.

crafty

2,291 posts

266 months

Sunday 11th May 2008
quotequote all
At a guess, your's would be from an Ultima.

Steve_D

13,802 posts

287 months

Sunday 11th May 2008
quotequote all
Try these guys.
http://www.vehicle-wiring-products.eu/VWP-onlinest...

I'm surprised you say two pin as mine is three pin (31, 49, 49a) but you may have changed to a different system.

Steve

V8OWNER

602 posts

264 months

Sunday 11th May 2008
quotequote all
its a hella led flasher relay, Ultima had to change mine as the loom was supplied with the 3 pin relay (which uses the load to control the flasher speed, hence not suitable for led lights).
silver hella unit only has 2 pins...

Davrianman

487 posts

293 months

Sunday 11th May 2008
quotequote all
If you are using LED indicator lights all round, then Kit Car Builders Solutions do a special LED relay so that you do not need balast resistors....

http://www.cbsonline.co.uk/led-flasher-relay-ledrl...

This has changed since I bought mine, but the functionality looks the same...

Mart

highflyer

Original Poster:

1,901 posts

255 months

Wednesday 14th May 2008
quotequote all

the flasher relay is an 1 inch tall and did have 3 pins but the middle one has been cut off onthe other end it has Flasher 3P.12V 32CP MAX.6
Is anybody familiar with this unit or know of a replacement unit, as a square one doesn't seem to fit properly, have now tried most motorfactors in and around my area and nobody has one or seen one this size.

Steve_D

13,802 posts

287 months

Wednesday 14th May 2008
quotequote all
There should be markings of some sort beside the pins.
This would give the best clue.

Like these
http://www.vehicle-wiring-products.eu/VWP-onlinest...

Steve

highflyer

Original Poster:

1,901 posts

255 months

Wednesday 14th May 2008
quotequote all
Yes Steve you are right it is very similar to the RLF4 model but it has the X and L pin but no P pin and it is half the length do you think this matters ?

Steve_D

13,802 posts

287 months

Thursday 15th May 2008
quotequote all
You say one of the pins has been cut off.
Are you sure it has not broken off and the wire connecting to it is still dangling under the dash somewhere?
May be the reason you need to replace it.

Steve

highflyer

Original Poster:

1,901 posts

255 months

Thursday 15th May 2008
quotequote all
No Steve the indicators started to flash quicker than normal but all bulbs were intact, so swapped the hazard relay for the indicator relay and all was fine again. I just want a spare for future, Was in the girl guides but was expelled for enjoying myself too much, but I did learn to, " always be prepared "