Crafty's stalks

[BIGNUMBER2]

Grant

Do you have any more pics of the mods you made on the indicator stalks?,
I'm trying to remove the hazard switch for a more snug fit, but electrics are a bit of a mystery to me.
Did you use the top circuit board? as far as I can tell its only for hazard switch and flasher relay.
Do you have a wiring diagram.

Cheers
Andy

[crafty]

What I did was I bought a second hand set of stalks and a new set. I started with the second hand set, then when I had it sorted I did the new set.

I cut the circuit board between the hazard and the rest of the assembly and soldered wires between the two circuit boards which allowed the hazard switch to be moved under the dash and the indicator and wiper assemblies to be moved in very close to the wheel.

The wiring was a nightmare, I started to draw it all out but it was doing my head in, so I "used the force" and just jumped in and fixed it as I went.

[spatz]

check out my ford stalks threat on the sticky board, I have yesterday succesfully tested the FORD stalks with the VWNr.99 intermittent programmable relay and the Ultima wiper motor. I will post the wiring scheme later.

[V8 Vum]

Crafty,

What did you use for connectors? When I got my stalks there were none! ...did you nick them from a scrappy?

..Also what relays types are needed?

Cheers

Keithy

[crafty]

I soldered new wires onto the terminals an used my own connectors

[spatz]

http://www.pistonheads.com/gassing/topic.asp?h=0&a...

here the wiring diagramm

[BIGNUMBER2]

Yeah ive seen that already, but what i need to know is the wiring diagram the same for the stalks Grant used?

[spatz]

naturally I cannot answer this but the part number I used are 95AG11K665
and I would suggest you get exactly the same as there are several variations of these type of FORD stalks.