De Walt battery won’t charge
Discussion
You'll need some copper wire (offcuts from an electrical rewire are best or from an old electrical appliance, mobile phone charger etc) or possibly even paper clips if nothing else to hand.
Connect positive to positive and negative to negative for a few seconds, no longer. May be a slight spark so do it outdoors away from gas etc and ensure your safety googles and gloves are on.
Should give the 'faulty' battery that little boost.
Then transfer it to the mains charger and it should hopefully begin charging.
Connect positive to positive and negative to negative for a few seconds, no longer. May be a slight spark so do it outdoors away from gas etc and ensure your safety googles and gloves are on.
Should give the 'faulty' battery that little boost.
Then transfer it to the mains charger and it should hopefully begin charging.
KTMsm said:
As poorly described above - take a quick look on youtube
Whilst I'd love to tell you get down off your high horse and to stop being a prize A end of a bell, I must say 'irony alert': your own attempt at a smug quick-witted message is ambiguous itself and speaks volumes about you. Unless you're totally thick, you'd know what I was talking about. Or is it the OP's post that you're confused about and are now confusing everyone about because you couldn't write a proper sentence yourself?I do however have to remind myself and accept that this is Pistonheads and that, as with every thread, the facetious, the smug and the holier-than-thou do crawl out of the woodwork early on, in many cases always looking for ways to put someone else down and play the man. If only there were dedicated threads on here or a telephone chat service for you to all mingle together. That'd be a fun place for you all, no?
For the record, you are the man. No really you are. I mean all the OP needed to do was go on YouTube and be told that, right? But you still went out of your way and were of great help by providing YouTube links and adding more detail to my post! Your insight, expertise, knowledge-sharing and clarifications on this topic really are a credit to you and of benefit to everyone, especially the OP.
Look I'm glad to heap this praise on you as you obviously need it and are a bit insecure and a bit special. For you though, I'd also be happy in future to give you what you want and make sure that every single little thing is described with infinite detail, added cartoon illustrations and simpler sentences.
captain.scarlet said:
Whilst I'd love to tell you get down off your high horse and to stop being a prize A end of a bell, I must say 'irony alert': your own attempt at a smug quick-witted message is ambiguous itself and speaks volumes about you. Unless you're totally thick, you'd know what I was talking about. Or is it the OP's post that you're confused about and are now confusing everyone about because you couldn't write a proper sentence yourself?
I do however have to remind myself and accept that this is Pistonheads and that, as with every thread, the facetious, the smug and the holier-than-thou do crawl out of the woodwork early on, in many cases always looking for ways to put someone else down and play the man. If only there were dedicated threads on here or a telephone chat service for you to all mingle together. That'd be a fun place for you all, no?
For the record, you are the man. No really you are. I mean all the OP needed to do was go on YouTube and be told that, right? But you still went out of your way and were of great help by providing YouTube links and adding more detail to my post! Your insight, expertise, knowledge-sharing and clarifications on this topic really are a credit to you and of benefit to everyone, especially the OP.
Look I'm glad to heap this praise on you as you obviously need it and are a bit insecure and a bit special. For you though, I'd also be happy in future to give you what you want and make sure that every single little thing is described with infinite detail, added cartoon illustrations and simpler sentences.
If your first reply was half as comprehensive as your second it would at least have been more informative - although wrong I do however have to remind myself and accept that this is Pistonheads and that, as with every thread, the facetious, the smug and the holier-than-thou do crawl out of the woodwork early on, in many cases always looking for ways to put someone else down and play the man. If only there were dedicated threads on here or a telephone chat service for you to all mingle together. That'd be a fun place for you all, no?
For the record, you are the man. No really you are. I mean all the OP needed to do was go on YouTube and be told that, right? But you still went out of your way and were of great help by providing YouTube links and adding more detail to my post! Your insight, expertise, knowledge-sharing and clarifications on this topic really are a credit to you and of benefit to everyone, especially the OP.
Look I'm glad to heap this praise on you as you obviously need it and are a bit insecure and a bit special. For you though, I'd also be happy in future to give you what you want and make sure that every single little thing is described with infinite detail, added cartoon illustrations and simpler sentences.

Tried the above and it has worked at least the battery took a charge, however don’t think it is taking full charge as it quickly slows down even under no load.
Will try charging/discharging and see how that goes.
For the benefit of doubt, method is
Line up good and bad batteries in same orientation
Using croc clips and wire connect the two nearest contacts together, repeat for the two furthest away.
Might get small spark as you connect second wire
I left them for two minutes
Will try charging/discharging and see how that goes.
For the benefit of doubt, method is
Line up good and bad batteries in same orientation
Using croc clips and wire connect the two nearest contacts together, repeat for the two furthest away.
Might get small spark as you connect second wire
I left them for two minutes
The science behind it is this:
Lithium chargers won't charge lithium(lipo/lifPo4 etc etc) batteries under around 2v per cell (18v tool batts are made up of 5 x 4.2v cells). The voltage is deemed too low to attempt charging and/or the charging circuit won't detect a pack under 10v (or it deems it too dangerous). Rough figures. It won't even "see " the pack as connected as it's looking for a higher voltage to trigger the charging process.
By linking the battery to a fully charged one, you are pumping voltage from the full pack into the empty one - just like linked tanks of water equalising. After a short time the dead pack's voltage lifts enough to trigger the charger into charging mode. Leaving them connected for a while won't do any harm as long as the cables used can handle the current.
When you DO take a lithium pack down to a voltage this low, you damage it and reduce it's capacity - often significantly.
Charge cycles (charging / discharging) is for old NiCads/NiMh. Won't make a jot of difference to Lithium cells.
Lithium chargers won't charge lithium(lipo/lifPo4 etc etc) batteries under around 2v per cell (18v tool batts are made up of 5 x 4.2v cells). The voltage is deemed too low to attempt charging and/or the charging circuit won't detect a pack under 10v (or it deems it too dangerous). Rough figures. It won't even "see " the pack as connected as it's looking for a higher voltage to trigger the charging process.
By linking the battery to a fully charged one, you are pumping voltage from the full pack into the empty one - just like linked tanks of water equalising. After a short time the dead pack's voltage lifts enough to trigger the charger into charging mode. Leaving them connected for a while won't do any harm as long as the cables used can handle the current.
When you DO take a lithium pack down to a voltage this low, you damage it and reduce it's capacity - often significantly.
Charge cycles (charging / discharging) is for old NiCads/NiMh. Won't make a jot of difference to Lithium cells.
There is a cunning trick you can try with a Dewalt battery, bereft of life, which involves wrapping the battery in many layers of newspaper and popping it in the freezer for a week.
After a week take your battery, wrapped in the many layers newspaper, and put it in the fridge for 48 hours.
After 48 hours remove the battery from the fridge and allow it to acclimatise to room temperature before removing the many layers of newspaper.
Then charge the battery and Bob's you uncle, it's a miracle !
Although many people have found success with this excellent method of battery resurrection, it's never worked for me.
Give it a go. Let me know how you get on.
Sooner or later it's bound to work for someone I know.
After a week take your battery, wrapped in the many layers newspaper, and put it in the fridge for 48 hours.
After 48 hours remove the battery from the fridge and allow it to acclimatise to room temperature before removing the many layers of newspaper.
Then charge the battery and Bob's you uncle, it's a miracle !
Although many people have found success with this excellent method of battery resurrection, it's never worked for me.
Give it a go. Let me know how you get on.
Sooner or later it's bound to work for someone I know.
Growing a handlebar moustache has never worked out for me. No reason why you shouldn't try growing some face furniture yourself.
https://www.large.net/news/89u43pm.html
https://www.large.net/news/89u43pm.html
loughran said:
Growing a handlebar moustache has never worked out for me. No reason why you shouldn't try growing some face furniture yourself.
https://www.large.net/news/89u43pm.html
:----~)https://www.large.net/news/89u43pm.html
Gassing Station | Homes, Gardens and DIY | Top of Page | What's New | My Stuff


