Adjusting UPVC Butt Hinges
Author
Discussion

Geertsen

Original Poster:

2,050 posts

90 months

Yesterday (20:31)
quotequote all




Can these UPVC door hinges be adjusted so that there is less compression on the hinge side?

I fitted a new universal seal to the door and there is too much pressure on the hinge side which is creating a gap at the bottom on the latch side and you have to push hard to close the door.

I’m yet to fit the internal seal (as can be seen in the photos) so I imagine it’s only going to get tighter if I do. I might have to get a thinner seal if it’s not adjustable.

Geertsen

Original Poster:

2,050 posts

90 months



It turns out you can adjust the compression with the Allen key slot on the top.

The top hinge adjusted perfectly but unfortunately the middle and bottom ones will not budge. And now to add to it I removed the hinge pin on the central hinge and now I can’t get it back in. It has one flat edge so I’m guessing it’s got to go in the correct orientation on the 360° axis…??

Geertsen

Original Poster:

2,050 posts

90 months



I’ve now managed to drop the hinge bolt back in.

I’ve loosened all the grub screws but these allen bolts do not want to turn. It’s bizarre.

Condi

20,559 posts

202 months

I replaced some of these a few months ago, and from memory the middle one didn't have any adjustment on it. You could only pivot around that hinge if that makes sense.

The bottom one might just have a lot of pressure on it, try lifting the door or get a longer hex key.