PH Engineers, Architects and All Round Geniuses sought
Discussion
I had an attempted delivery of a Sofa on Thursday. The dimensions were 230x78x76cm. The sofa couldn't get to the top of the steps. The delivery guys said even if it had, it wouldn't go any further because of the slope on the roof (caused by the next set of steps).
There is an existing sofa in my flat, with dimensions of 166x95x68cm, which I presume fitted around that corner.
I am looking at an alternative from the same manufacturer of the failed delivery where the dimensions would be 154x78x76cm.
This is the turn:


Which measurements do the PH collective need to tell if it will fit?
There is an existing sofa in my flat, with dimensions of 166x95x68cm, which I presume fitted around that corner.
I am looking at an alternative from the same manufacturer of the failed delivery where the dimensions would be 154x78x76cm.
This is the turn:
Which measurements do the PH collective need to tell if it will fit?
I remember having this same problem but at the time I had a lot of spare time on my hands and made a model of both the sofa and staircase on AutoCAD and made sure it fitted (only just) the delivery guys weren't keen on giving it a go at first though.
You also can't be sure what the packaging will be like, you don't want to have to take it all off and rub it along the walls so you will need to leave a safety margin for the padding.
Good luck!
You also can't be sure what the packaging will be like, you don't want to have to take it all off and rub it along the walls so you will need to leave a safety margin for the padding.
Good luck!
The guys who tried to deliver the sofa said there were 2 issues:
1) Getting the sofa upright at the top of the stairs (it was too tall)
2) Swinging the sofa over the rail (the pitch from the next stairs severely limits this)
The new sofa i'm looking at should stand up easily (being 76cm shorter) and should fit through the gap between the railing and window...
I think I've convinced myself it will fit... any naysayers?
1) Getting the sofa upright at the top of the stairs (it was too tall)
2) Swinging the sofa over the rail (the pitch from the next stairs severely limits this)
The new sofa i'm looking at should stand up easily (being 76cm shorter) and should fit through the gap between the railing and window...
I think I've convinced myself it will fit... any naysayers?
shirt said:
why couldn't you get it up the stairs?
simply, what is the height of the ceiling? if it will stand up, it will go round. even if not it should still make it with a bit of jimmying.
failing that, send it by email.
See above. It wouldn't clear the top step by about 5-10cm, then it was too big to be shuffled around the railing...simply, what is the height of the ceiling? if it will stand up, it will go round. even if not it should still make it with a bit of jimmying.
failing that, send it by email.
The key to getting a sofa up a flight of stairs like that is to 'pivot'
http://www.youtube.com/watch?v=B_PklVas9cA&fea...
http://www.youtube.com/watch?v=B_PklVas9cA&fea...
Don't try and stand it upright to turn it. If you carry it tipped towards the front of the sofa, with the back of the sofa uppermost, the top of the sofa back towards the bannister and the underside of the sofa nearest the wall, then the leading arm of the sofa goes round the bannister while the back of the sofa goes over the bannister. You can then almost lift the whole thing over the bannister as you turn. This will give you a much tighter turning circle than trying to get the whole thing round the bannister or trying to stand it upright where there is limited headroom.
Ross is right, in principal.
Ross is right, in principal.
Gassing Station | Homes, Gardens and DIY | Top of Page | What's New | My Stuff






t into s