Treating Wooden Kitchen Worktop
Treating Wooden Kitchen Worktop
Author
Discussion

Howitzer

Original Poster:

2,865 posts

246 months

Friday 28th January 2011
quotequote all
Hi all,

The worktop in the kitchen needs some attention. We love the look and the feel but it isn't very well protected and marks very easily.

There are fine cracks in the surface in the most used areas and the grooves for the drainage board are stained black. It looks like it has never been treated in any way since it was installed.







Would this be just a case of a light rub down and then a clear varnish? We like the matt finish as it is warm and natural looking but also need the practicality so i'm not worrying about the worktop all the time tongue out

Any advice is much appreciated.

Dave!

Simpo Two

92,990 posts

295 months

Friday 28th January 2011
quotequote all
Give it a damn good sanding - that stain probably goes down 1-2mm. After that you can either use teak oil or a specialised synthetic varnish like Polyx Oil (which comes in gloss, satin and matt I think)

m3jappa

6,950 posts

248 months

Friday 28th January 2011
quotequote all
b&q do an oil which is for kitchens, hygenic sumin or ova ?

When i did mine i rubbed them back to bare wood (lots of boring work) Then i used a coloured danish oil (jakobean oak) 2 or 3 coats and then 2 coats of the hygenic stuff which is clear.

Made an enormous difference and probably looked better than new.

Shaw Tarse

31,901 posts

233 months

Friday 28th January 2011
quotequote all
Have a word with Mobile Chicane (I think she oiled her tops?)

Spudler

3,985 posts

226 months

Friday 28th January 2011
quotequote all
Wire wool, sand it and treat with Rustins Danish Oil.

sleep envy

62,260 posts

279 months

Friday 28th January 2011
quotequote all
fnar!

I did ours a few months back, it's a pain in the arse - lots of rubbing with very fine paper and tack rags to lift all the fine dust

I used a Sikkens matt finish oil as I'm not a big fan of varnished wood or gloss finishes

Griff Boy

1,563 posts

261 months

Saturday 29th January 2011
quotequote all
Spudler said:
Wire wool, sand it and treat with Rustins Danish Oil.
Wot he said!

Rustins is the oil finish recommended by my suppliers of solid timber tops, also the combination of initial sanding and the wire wool before and between coats is good advice.

I would apply a min of 3 coats, allowing the surface to dry properly between coats. Always keep on top of the wet areas especially. The drained grooves are a PITA! It may be worth starting to use a plastic drainer board that sits on the top and can ge put away afterwards. Most of the black damage is caused by water sitting on the wood and no being wiped down properly.

Howitzer

Original Poster:

2,865 posts

246 months

Saturday 29th January 2011
quotequote all
Many thanks for all the replies smile

We use a strainer which catches any dripping water underneath it and wipe the top down religiously, I'm terrified of spilling some Spagetti Bolognaise on it eek

I'll wait till Missus Howitzer goes to work and do it then, 3 coats in a day should be doable, hopefully there is no colour change.

I shall post up a picture when I get it done.

Dave!

louiebaby

11,000 posts

221 months

Saturday 29th January 2011
quotequote all
Shaw Tarse said:
Have a word with Mobile Chicane (I think she oiled her tops?)
wink