Ford EML after plug change
Ford EML after plug change
Author
Discussion

CoreyDog

Original Poster:

886 posts

120 months

Thursday 8th September 2022
quotequote all
Evening all.

So I serviced our 2011 S Max 2.0 Ecoboost 240 this morning. Changed oil, oil filter, air filter and spark plugs.

Drove home from work after the service (About 4 miles) and drove absolutely fine. No misfire etc. Car didn’t get up to temp though, only a 6 minute drive.

Gone to nip to the supermarket tonight and the EML light is on, showing solid amber, no blinking. Fires up first touch of the button and again, no misfire.

Did abit of Googling and apparently a solid light which doesn’t go off is related to anti-pollution. Could this be linked to the new plugs? Going to see my mate tomorrow who has a code reader but I have a fair bit to do before then which needs the car but I’m abit conscious of causing some damage.

Any advice, experience or tips?

Thanks

Tony1963

5,808 posts

192 months

Thursday 8th September 2022
quotequote all
If your engine has trouble warming up, I'd guess the thermostat is stuck open. That can throw up an EML light, my old Mk4 Golf 1.8T had exactly that.

CoreyDog

Original Poster:

886 posts

120 months

Thursday 8th September 2022
quotequote all
Sorry, perhaps should have been clearer. Before the service it had no issue at all getting up to temp. Since the service I haven’t given it along enough drive to actually get up to temp yet, engine only been running less than 6 minutes just to get from work (Where I serviced it) to home.

I suspect that could be a contributor factor given it’s an anti pollution warning (I think!). Bit cautious about giving it a drive to get up to temp though with the light showing.

Tony1963

5,808 posts

192 months

Friday 9th September 2022
quotequote all
Disconnect the battery for 15 minutes, reconnect, light should clear, go for a 25 mile drive, see what happens.
Maybe put some new, decent fuel in it too.

Regularly driving a car but not getting the engine up to temperature is cruel and asking for trouble.

Scrump

23,943 posts

188 months

Friday 9th September 2022
quotequote all
Get the code reader on it. Not much point in speculation, wait until you have the code and take it from there.

E-bmw

13,462 posts

182 months

Friday 9th September 2022
quotequote all
Scrump said:
Get the code reader on it. Not much point in speculation, wait until you have the code and take it from there.
^^^^Wot 'e said.

Too many possibilities to speculate.