Tooltec plus 24L air compressor
Discussion
Tooltec plus 24L air compressor....just sort of gifted it when asking my dads other half if he just happened to have one on leaving today.
- Well when you consider poor old dad isn't going to be so much as filling a tyre or driving let alone anything else, too busy tapping on his armchair (dementia) frown I was told I could have it by his SoH
We haven't located the manual yet, found one similar but doesn't seem to cover the oil plug display thing.
Don't suppose anyone has a manual for one of these scanned?
Otherwise just referring to similar ones though for safety advice etc
https://www.manuals.co.uk/parkside/pko-24-a1/manua...
I have drained and refilled the oil at least, and no water evidence inside the tank ( don't think it was ever used at all ).
Looks like he may have midhandled and damaged the air filter part in storage, as I only have a flat screw in part without nothing attached to it.
I either have to glue some foam to what is left, or take a look in ebay - looks like its around 15/16mm thread
Update: I've managed to bodge together a temporary air filter, consisting of part of a brillo foam squeezed into a plastic can cap
It works....Just until I can get a 16mm silencer filter ordered on ebay
Looking to play about with some kind of cheap spray gun setup - anything I should look out for that, planning to get a filter to add in line too?
Update:
On researching I have ordered an A.N.I GF3 from spraygunsdirect.....should be good to go, am aware this is very low in capacity and only for short stints of spraying
- Well when you consider poor old dad isn't going to be so much as filling a tyre or driving let alone anything else, too busy tapping on his armchair (dementia) frown I was told I could have it by his SoH
We haven't located the manual yet, found one similar but doesn't seem to cover the oil plug display thing.
Don't suppose anyone has a manual for one of these scanned?
Otherwise just referring to similar ones though for safety advice etc
https://www.manuals.co.uk/parkside/pko-24-a1/manua...
I have drained and refilled the oil at least, and no water evidence inside the tank ( don't think it was ever used at all ).
Looks like he may have midhandled and damaged the air filter part in storage, as I only have a flat screw in part without nothing attached to it.
I either have to glue some foam to what is left, or take a look in ebay - looks like its around 15/16mm thread
Update: I've managed to bodge together a temporary air filter, consisting of part of a brillo foam squeezed into a plastic can cap
It works....Just until I can get a 16mm silencer filter ordered on ebay Looking to play about with some kind of cheap spray gun setup - anything I should look out for that, planning to get a filter to add in line too?
Update:
On researching I have ordered an A.N.I GF3 from spraygunsdirect.....should be good to go, am aware this is very low in capacity and only for short stints of spraying
Edited by daytonavrs on Monday 10th August 19:53
Gassing Station | Home Mechanics | Top of Page | What's New | My Stuff