Getting a badge of with minimum paint loss!
Getting a badge of with minimum paint loss!
Author
Discussion

Russ_UK

Original Poster:

6 posts

283 months

Tuesday 15th April 2003
quotequote all
What's the best way to get one of those plastic badges off the side of a car.

I've got a Rover 200 and want to remove the little rover badges they stick on behind the rear side windows but worried I'm gonna pull the paint of with it.

I used a hair dryer when I had my Nova but don't think that will work this time.

FastShow

388 posts

283 months

Tuesday 15th April 2003
quotequote all
I've always found a hairdryer and dental floss is the best way to go.

m-five

12,399 posts

315 months

Tuesday 15th April 2003
quotequote all
Hair dryer is still the chosen method - that's how I debadged my M5!

pete_w

646 posts

294 months

Tuesday 15th April 2003
quotequote all

m-five said: Hair dryer is still the chosen method - that's how I debadged my M5!


Why did you take the badges off? -I can understand with a Rover but an M5?

nmlowe

1,666 posts

298 months

Tuesday 15th April 2003
quotequote all

pete_w said:

m-five said: Hair dryer is still the chosen method - that's how I debadged my M5!


Why did you take the badges off? -I can understand with a Rover but an M5?




So the 'Turbo NOS Injected Super Motorsport Special Edition' badges have some room, stupid!




>> Edited by nmlowe on Tuesday 15th April 13:59

rob.ellis

2,863 posts

309 months

Tuesday 15th April 2003
quotequote all

FastShow said: I've always found a hairdryer and dental floss is the best way to go.


fishing line works too. no scratching

mikeylad

34,595 posts

284 months

Tuesday 15th April 2003
quotequote all
blow-torch. save time...

mikeylad

34,595 posts

284 months

Tuesday 15th April 2003
quotequote all
or the 'wobbly tooth' technique.

(tie string to badge and an open door. slam door. still hurts like kcuf though worked for worsel gummidge, IIRC.

mrsd

1,502 posts

284 months

Tuesday 15th April 2003
quotequote all
The badges are definitely only glued on ? You could get a nasty shock if there turns out to be a 5mil hole underneath for the peg on the back of the badge. Just a thought...

jon h

863 posts

315 months

Tuesday 15th April 2003
quotequote all
I have some experience of this issue, as we make badges for a number of vehicle manufacturers...If you are talking about an injection moulded badge, the adhesive is usually in the form of a foam pad. By pulling the badge off the foam will often break before the adhesive. You are then left with some foam and adhesive to be removed by gentle rubbing, plus a solvent. (test solvent on a hidden bit of paint work first!) It would be very very unusual to see the adhesive damage the paint unless it is a dodgy respray.

Jon H

llamekcuf

545 posts

285 months

Tuesday 15th April 2003
quotequote all
wd40 and a credit card

m-five

12,399 posts

315 months

Tuesday 15th April 2003
quotequote all

pete_w said:

m-five said: Hair dryer is still the chosen method - that's how I debadged my M5!


Why did you take the badges off? -I can understand with a Rover but an M5?




I didn't want to show off - it is just so passé!

Also I wanted to fit my 538i badge - it's the only 538i in the country