Will this fail the MOT?
Author
Discussion

JohnL

Original Poster:

1,766 posts

296 months

Wednesday 23rd April 2003
quotequote all
I've got a Mk1 MR2, which I've been fixing using parts from my old mk1 MR2 which was definitely more spares than repair.

Anyway I reckon it's about done (OK it only involved swapping a wing, a door and a valance ).

But - I've discovered a that a drain hole in the bottom of the front boot is a bit corroded around the edges. The bung for it is a bit loose and when it's in place there's a distinct gap at one side.

Will this be an MOT failure? If so, would it be enough to patch it with fibreglass or will it need to be welded?

The other question is about wheelbolts. The wheels on the car have one bolt each that is too long - it sticks out by 30mm or so. Again, will this fail the MOT test?

agent006

12,058 posts

295 months

Wednesday 23rd April 2003
quotequote all

I've got a Mk1 MR2, which I've been fixing using parts from my old mk1 MR2 which was definitely more spares than repair.

Anyway I reckon it's about done (OK it only involved swapping a wing, a door and a valance ).

But - I've discovered a that a drain hole in the bottom of the front boot is a bit corroded around the edges. The bung for it is a bit loose and when it's in place there's a distinct gap at one side.

Will this be an MOT failure? If so, would it be enough to patch it with fibreglass or will it need to be welded?

The other question is about wheelbolts. The wheels on the car have one bolt each that is too long - it sticks out by 30mm or so. Again, will this fail the MOT test?


I think rust will only fail a car if it's affefcting the structure.

deltaf

6,806 posts

284 months

Wednesday 23rd April 2003
quotequote all
Or if sharp edges are accessible to joe public when you run him over....

JohnL

Original Poster:

1,766 posts

296 months

Wednesday 23rd April 2003
quotequote all
Well it certainly ain't structural - thanks guys!