PC Problem URGENT Help please.
Discussion
You need a boot disk, otherwise known as startup disk, system disk or recovery disk. It'll be a 3 1/2 inch floppy disk, normally supplied with a pre-assembled machine.
Once you've got one, stick it in the a drive and type;
dir/w
That will bring up a list of what's on the disk. Look for 'setup.exe' 'extract.exe' or something similar.
To run them just type the name (no need for the .exe bit).
The rest should be automated.
I should be on my computer for a while yet, email me with any extra questions...
Hope this helps.
>> Edited by Alan420 on Sunday 27th April 15:13
Once you've got one, stick it in the a drive and type;
dir/w
That will bring up a list of what's on the disk. Look for 'setup.exe' 'extract.exe' or something similar.
To run them just type the name (no need for the .exe bit).
The rest should be automated.
I should be on my computer for a while yet, email me with any extra questions...
Hope this helps.
>> Edited by Alan420 on Sunday 27th April 15:13
In addition to the other comments, to set the BIOS to look for the CD you have to restart the computer, hold the delete key to enter the BIOS setup menu (bright blue usually, u can't miss it).
Once in there use the arrow keys to scroll through the various menus till you find the list of 'boot devices'. Use the Page up and Page down keys (above the arrow keys, on the right) to change them.
Once in there use the arrow keys to scroll through the various menus till you find the list of 'boot devices'. Use the Page up and Page down keys (above the arrow keys, on the right) to change them.
Al. followed your route i.e @ A: prompt typed in setup
and pressed enter screen now reads
CDR101:not ready reading drive E,ABORT RETRY FAIL?
I 'm a middle man and the person on the other end of the email is not too PC literate.
Thanks again all for inputs so far.
>> Edited by Big Al. on Sunday 27th April 19:10
and pressed enter screen now reads
CDR101:not ready reading drive E,ABORT RETRY FAIL?
I 'm a middle man and the person on the other end of the email is not too PC literate.
Thanks again all for inputs so far.
>> Edited by Big Al. on Sunday 27th April 19:10
Sounds like the boot disk you are using does not have the device drivers on it for the CD-ROM drive. Type in "dir" and see if there is anything like "CDROM.SYS", and if "MSCDEX.EXE" is present.
If not, you won't be able to get at the CD-ROM using that disk. If they are there, try typing in:
"type autoexec.bat"
you should get a listing of loads of commands - one should look like
"mscdex.exe /d: cdrom01" or something.
Then try
"type config.sys"
you should get
"DEVICE=CDROM.SYS /d:CDROM01" or something.
If these are not there, it will not get the CD-ROM going. It'll have to be over to some other DOS-expert PHer to remind me exactly what syntax gets the CD going!
If not, you won't be able to get at the CD-ROM using that disk. If they are there, try typing in:
"type autoexec.bat"
you should get a listing of loads of commands - one should look like
"mscdex.exe /d: cdrom01" or something.
Then try
"type config.sys"
you should get
"DEVICE=CDROM.SYS /d:CDROM01" or something.
If these are not there, it will not get the CD-ROM going. It'll have to be over to some other DOS-expert PHer to remind me exactly what syntax gets the CD going!
Big Al. said: Al. followed your route i.e @ Arompt typed in setup
and pressed enter screen now reads
CDR101:not ready reading drive E,ABORT RETRY FAIL?
I 'm a middle man and the person on the other end of the email is not too PC literate.
Thanks again all for inputs so far.
Erm. That sounds like it is looking for a cd drive.
Now, does your mate have a operating system on a floppy or cd rom.
It should be a cd rom unless the pc is really old.
So, if he has a cd with windows on it, make sure there is no floppy in the computer, put the cd in and boot it.
Gassing Station | General Gassing [Archive] | Top of Page | What's New | My Stuff



rompt typed in setup 