Panel filter upgrade in a ZR 120 (K series )
Discussion
I've been looking at K&N and Green direct replacement panel filters recently, are they any good?
Will I notice any difference with it on a K series in an MG ZR 120?
I'd go for a full typhoon induction kit but the missus is using it to commute at the moment and isn't overly keen on it being too loud, plus I used to have a 106 with a 57i kit on it and that gave me a headache over long distances!
Will I notice any difference with it on a K series in an MG ZR 120?
I'd go for a full typhoon induction kit but the missus is using it to commute at the moment and isn't overly keen on it being too loud, plus I used to have a 106 with a 57i kit on it and that gave me a headache over long distances!
you might have already looked at the page below but i'll post it anyway
http://www.mgf.ultimatemg.com/group2/air_filters/f...
all mgf stuff but it still relates to the mems 1.9/3 and the vvc mems 2j
i had a 1600 mems 1.9 in a metro and with a cone bunged straight on the end of the throttle body i got super sharp response. it might have hurt power not being a cold air intake mathingy but to me, i'm happy to sacrifice a couple bhp for response
makes my mx5 feel like a diesel in comparison
http://www.mgf.ultimatemg.com/group2/air_filters/f...
all mgf stuff but it still relates to the mems 1.9/3 and the vvc mems 2j
i had a 1600 mems 1.9 in a metro and with a cone bunged straight on the end of the throttle body i got super sharp response. it might have hurt power not being a cold air intake mathingy but to me, i'm happy to sacrifice a couple bhp for response
makes my mx5 feel like a diesel in comparison
Lots of cheap mods you can do on the K without changing the ECU.
Panel filter and a 52mm throttle body come to mind
Another cheap (almost free mod) is to take the intake plenum apart and get rid of all the plastic moulding swarf (or pick up a nice VVC metal plenum from a scrapper).
Then a 4-2-1 exhaust manifold and decent exhaust could take you upto 140bhp quite easily (which is about the limit for the MEMs ECU)
Panel filter and a 52mm throttle body come to mind
Another cheap (almost free mod) is to take the intake plenum apart and get rid of all the plastic moulding swarf (or pick up a nice VVC metal plenum from a scrapper).
Then a 4-2-1 exhaust manifold and decent exhaust could take you upto 140bhp quite easily (which is about the limit for the MEMs ECU)
Gassing Station | General Gassing [Archive] | Top of Page | What's New | My Stuff


