Treating / Curing Rust
Author
Discussion

garycat

Original Poster:

5,439 posts

241 months

Monday 22nd March 2010
quotequote all

My daughter's Ford Ka is rusting quite badly on the plate that holds the bonnet catch loop to the bonnet. The loop still feels very solid but I want to remove the flaking rusty metal from the plate and treat what is left it with something & prime it to prevent further problems.

Any suggestions? I seem to remember something that chemically changes the rust back into metal?

K87

2,111 posts

218 months

Monday 22nd March 2010
quotequote all
wire brush attachment or flap wheel attachment in drill, get it nice and clean then repaint it.

These chemical things don't really work that well, once the rust is set in the best way is just to remove it all completely.

Outbound

342 posts

214 months

Monday 22nd March 2010
quotequote all
For bits you can remove, buy el cheapo vinegar from your supermarket and let the parts sit in a plastic bucket full of vinegar for a couple of days, brushing with a stiff brush each night.

Good as new, unless the parts are all rust as the vinegar removes it!

EDIT:When done, rinse and dry the bits and paint them with hammerite or something as they will corrode quickly after being cleaned back to bare metal.

Edited by Outbound on Monday 22 March 13:28

TheLurker

1,589 posts

227 months

Monday 22nd March 2010
quotequote all
Wire brush as much rust off as you can, then treat with a rust treatment like Kurust and repaint. It is very difficult to completley remove rust, and it may come back in a few years.

HellDiver

5,708 posts

213 months

Monday 22nd March 2010
quotequote all
K87 said:
These chemical things don't really work that well, once the rust is set in the best way is just to remove it all completely.
You're using the wrong chemical, then...

Google "Vactan", get some, paint it on, never see rust again.

monthefish

20,467 posts

262 months

Monday 22nd March 2010
quotequote all
TheLurker said:
Kurust
Was going to say this, but for cosmetic (i.e. non-structural) only. Not sure I'd be using it on bonnet catches though (but I suppose that depends on how bad the rust has got).