Jaguar superchargers - question re power.
Jaguar superchargers - question re power.
Author
Discussion

drivin_me_nuts

Original Poster:

17,949 posts

242 months

Monday 22nd March 2010
quotequote all
I'm hoping someone can answer this question. I think I have got my wires crossed and have not heard something correctly.

.. that the jag supercharger as uses in the S type R takes over 100bhp to run at full power. Is this true or just a load of old baloney?

Cheers

Marquis_Rex

7,377 posts

270 months

Monday 22nd March 2010
quotequote all
It's bks, the Eaton M112 takes about 70 Bhp to run at full load. Under part load conditions it is by passed however-so it has minimal impact on fuel economy.
A Rootes blower is able to do this because it is a positive displacement device- ad does no internal work- it only supplies a volume.

Bypassing a Lysholm compressor or centrifugal compressor in this way wouldn't work under part load conditions as it DOES do internal compression work.

Fruitcake

3,850 posts

257 months

Monday 22nd March 2010
quotequote all
When the engine produces 400bhp and about as much torque, why would you care what the blower takes off to make it?

Not having a dig, just never understood the musings.

varsas

4,077 posts

233 months

Monday 22nd March 2010
quotequote all
It's useful when understanding the differences in compressors. It's also helpful when looking at electic superchargers and trying to decide how likely it is that they can actually do any good or not. Besides, it's all part of understanding how supercharged cars work, isn't it?

Edited by varsas on Monday 22 March 18:11

buzzsaw

698 posts

300 months

Monday 22nd March 2010
quotequote all
Well the non supercharged S Type runs at approx 300 bhp, with the supercharged version at approx 400 bhp, so the supercharger adds 100 bhp net, but not sure how much it parasitically takes.

Pigeon

18,535 posts

277 months

Tuesday 23rd March 2010
quotequote all
Fruitcake said:
When the engine produces 400bhp and about as much torque, why would you care what the blower takes off to make it?

Not having a dig, just never understood the musings.
Consider an extreme example - a gas turbine engine. The turbine section in the Great Western's experimental locomotive No. 10000 produced about 9000bhp... but the compressor section consumed about 6000bhp, leaving only a third of the power available at the output shaft.

Gas turbines are like this because they compress a lot more air than is used for combustion - the excess is used to cool the combustion product gases to keep the turbine inlet temperature down to manageable levels. The situation gets worse when you reduce the output power as the power consumed by the compressor stays the same so even at tickover it's still using two-thirds the fuel it does at full whack. This is why gas turbine locomotives have never been popular - while their full load fuel consumption can be competitive, very few rail duties allow them to run continuously at full load for a high enough proportion of the time to offset the terrible part-load consumption.