Discussion
Good afternoon all
I'm after a little feed back on my ford mondeo st not starting starting its on a 2007 plate and the 2.2 diesel.
It's got no fuel going to the injectors and no signs of metal swarf on the top of the injectors. Also the battery has been dissconnect for a day or two there was a code logged it was P0251 I think off the top of my head, which does relate to the fuel system do I need reprogram anything or is a fault on the vehicle.
Any information should helpful thank Teejay.
I'm after a little feed back on my ford mondeo st not starting starting its on a 2007 plate and the 2.2 diesel.
It's got no fuel going to the injectors and no signs of metal swarf on the top of the injectors. Also the battery has been dissconnect for a day or two there was a code logged it was P0251 I think off the top of my head, which does relate to the fuel system do I need reprogram anything or is a fault on the vehicle.
Any information should helpful thank Teejay.
In the simplest terms, the pump won't develop any kind of pressure it there is a leak, real or artificial like opening the high pressure connection at the pump or the fuel rail. No, timing isn't critical, it is what it is; a pump. The ECU controls duration and timing of injection by telling the injectors when to open. I really do reccomend gathering as much info as possible before going ahead. Usually though there really only are the usual reasons for failure of this sort. As an observation, don't try and tow start the car as you will risk killing the dual mass flywheel too.
v64paul said:
In the simplest terms, the pump won't develop any kind of pressure it there is a leak, real or artificial like opening the high pressure connection at the pump or the fuel rail. No, timing isn't critical, it is what it is; a pump. The ECU controls duration and timing of injection by telling the injectors when to open. I really do reccomend gathering as much info as possible before going ahead. Usually though there really only are the usual reasons for failure of this sort. As an observation, don't try and tow start the car as you will risk killing the dual mass flywheel too.
Good advice. Tow starting and using booster packs is no longer a simple job with the increased complexity of electrical and mechanical systems in cars in recent years. Without a doubt car electricians are going to be the master class in car mechanics in the future. The effects of remapping are only the begginings of the changes that will come. Dial up tuning is on its way.Very very unlikely if im honest. The pumps a complete assembly from Ford - although there is a metering valve and a temperature sensor available seperately. My advice would be get it onto Ford's IDS - this will allow them to give you a bit more information. The only downside is there can often be more than one fault 

Again the keys just wouldnt lose the code because power is lost. It wouldnt crank if the immobiliser had kicked in - would just flash the clock light repeatedly. Im guessing its cranking or its pointless cracking the HP pipes off the injectors to see if diesel is flowing.
The only saving grace the OP may have is a blocked fuel filter possibly? Id change that first and foremost with any diesel running issue.
The only saving grace the OP may have is a blocked fuel filter possibly? Id change that first and foremost with any diesel running issue.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff


