Exhaust stolen, Lambda sensor woes.
Exhaust stolen, Lambda sensor woes.
Author
Discussion

keemaklan

Original Poster:

419 posts

181 months

Thursday 11th April 2013
quotequote all
Had some toerags steal my 2007 Mercedes Sprinter 311's entire exhaust system including the cat (obviously). The cheeky beggars weren't even phased by my CCTV camera's or the fact the van was parked on my driveway. They were in and out in less than 15 minutes and left me with potentially huge bills.

I trawled through the internet for a used exhaust, but I didn't really want to entertain the possibility of paying the same thieves who stole my exhaust to sell me one back so decided to get a custom made exhaust fabricated today for £200.

Now comes the problem. The thieves were obviously in a rush to go do the next van and so cut the two lambda sensors rather than unclipping them so I have an engine management light on. Lambda sensors are preposterously expensive and having got quotes of £300+ for Lambda sensors and labour charges I am faced with a tricky situation. I don't want to be £500 out of pocket! Is there any tricks to get the engine to think the lambda sensors are still in the exhaust without buying new ones? Used ones aren't much cheaper.

Also, if I do buy a used lambda sensors and fit them in, will the engine light go out considering I am now cat-less and intend on remaining so.

Thanks for any genuine or funny replies given...

nails1979

643 posts

172 months

Thursday 11th April 2013
quotequote all
Theyre not 500 quid unless you get them from the stealers. Should be loads cheaper online.

Hear about this a lot though on vans. With the ground clearance must make it quite easy and get decent money for cats at a scrappy.

Sedox

17 posts

181 months

Thursday 11th April 2013
quotequote all
What engine is fitted in the van?

MysteryLemon

4,968 posts

222 months

Thursday 11th April 2013
quotequote all
The engine needs the lambda sensors to run properly.

The ecu will likely be able to start and run the engine but won't be able to do it efficiently or smoothly etc. infact, if the ecu let's you start it at all, it will probably go straight into limp mode until you connect the lambda again.

Also, you will likely have to visit a dealer to get the warning light reset.

Remagel2507

1,456 posts

223 months

Thursday 11th April 2013
quotequote all
We did loads of these last year that had had the DPFs stolen and all I know is that they were absolutely flat until they the ECU had been told that the DPF had been replaced and for some reason not all of them reset easily.

What you could do is try and find a company that does DPF deletes and see if that delete will also include the sensors i.e their readings are no longer relevant, this should then mean that you can drive without the sensors but without having to have the van in constant limp mode.

keemaklan

Original Poster:

419 posts

181 months

Thursday 11th April 2013
quotequote all
Sorry, I should have made it clearer.

The exhaust cost me £200.

The lambda sensors at breakers will set me back £200+vat so I'll be looking at an over all bill of £500.

One of my friends had his vans exhaust nicked recently too. He claimed off his insurance. Insurance wrote the van off and was paid out £4000. Not looking to go down that route though. Just want it fixed on the cheap.


Edited to add the following:

1)Sedox, don't know the engine code but I'll have a look and get back to you.

2) MysteryLemon, the van starts fine, it drives absolutely fine. It also sounded EPIC without any exhaust at all and with the gases going straight to atmosphere from turbo. Lovely turbo whistle that I now miss.
The van has full power and is not down on power.

3)Remagel, ours doesn't have a DPF (though funnily enough the garage yesterday I took it to were adamant that it did, but I'm 100% sure it doesn't.) It is not going into limp mode. Its just got the engine light on.

Thanks guys.

Edited by keemaklan on Thursday 11th April 22:40


Edited by keemaklan on Thursday 11th April 22:41

Pipster1969

698 posts

199 months

Thursday 11th April 2013
quotequote all
This happened to someone I know and guess what happened the day he got it replaced? They came back.

Sedox

17 posts

181 months

Thursday 11th April 2013
quotequote all
If its a non DPF then the cat does not need to be fitted for MOT so you are OK on that point as it will still pass the smoke test. A very fussy MOT tester will pick up on it if they spot its been removed.

The front lambda sensor is important (does it have 2)? As this plays a part in controlling fuel mapping (if its an EDC16 ECU this will not bring on limp mode but it will not run perfectly) the 2nd lambda (if fitted) is a diagnostic lambda that checks the efficiency of the cat and is simple to map out by altering the values it looks for.

Try ECP for lambda sensors.

Remagel2507

1,456 posts

223 months

Thursday 11th April 2013
quotequote all
OP I'm really surprised it doesn't have a DPF all the 2007+ ones we have had in have had them, I would still try and find a local company that specializes in the DPF deletes as may be able to help you as far as deleting the sensors from the ECU is concerned

Sedox

17 posts

181 months

Thursday 11th April 2013
quotequote all
If it was a dpf vehicle it would have 2 pressure pipes, 1 lambda sensor and 2 temperature sensors.

keemaklan

Original Poster:

419 posts

181 months

Friday 12th April 2013
quotequote all
Right, thanks for the replies.

Sedox, I had a look at the log book but no information on engine code.

Spoke to a commercial breaker who told me apparently all sprinter vans have DPF's so I take it I had a DPF on mine as well. Was well surprised actually because in the 3 years I've had it, its only ever done a daily journey of 6 miles return and one day a week cash and carry trip of 20 miles odd. Never a problem with the DPF.

Sedox, thanks for the information on the sensors I need. I'm going to guess that if I get the imaginary DPF deleted, then the only sensor that I'll need will be the ONE lambda sensor still in place?

Remagel, sorry you were probably right on the DPF aspect. Where are you guys based?

mat777

10,714 posts

191 months

Friday 12th April 2013
quotequote all
Pipster1969 said:
This happened to someone I know and guess what happened the day he got it replaced? They came back.
Buy a 240v inverter and wire it into the van. Wire a plug from this to the exhaust that you can plug in and leave on all night smile

ehonda

1,483 posts

236 months

Friday 12th April 2013
quotequote all
Absolutely no help at all, but I suggest you have a word with that dog in your profile picture!
I guess the absence of a cat will mean that you won't get hit twice at least.
<partridge>scum, subhuman scum</partridge>

Fire99

9,868 posts

260 months

Friday 12th April 2013
quotequote all
Have you googled 'universal lambda sensors'? I bought some for a Lexus a few years ago and they worked just fine and I think they cost me about 15 quid each or so.

callmedave

2,686 posts

176 months

Friday 12th April 2013
quotequote all
Sedox is correct, The first/primary lambda will need to be installed, the secondary you can use something like this: http://i607.photobucket.com/albums/tt160/roygrave/...

The red bit is a blanking sleeve and can be cable tied up somewhere under the vehicle.

Hope this helps!

r11co

6,244 posts

261 months

Friday 12th April 2013
quotequote all
Fire99 said:
Have you googled 'universal lambda sensors'? I bought some for a Lexus a few years ago and they worked just fine and I think they cost me about 15 quid each or so.
Lambda sensors are relatively cheap and are fairly generic. The trick is finding the correct one and if it doesn't come with the correct connector figuring how to wire it up. Worth the hassle for the hundreds you can save.

keemaklan

Original Poster:

419 posts

181 months

Saturday 13th April 2013
quotequote all
Thank you guys. Hopefully have it sorted soon and then I'm part ex-ing and changing!