Breaking the bond: Alloy wheel removal
Discussion
Hi guys. Recently picked up a daily driver of an e61 5 series. The iDrive has been nagging at me to sort the rear brake pads, so I got onto ECP's site and got some kit delivered and set to over the weekend.
So, I found the crappy plastic jack point and got it in the air. The undercarriage is a vast display of plastic so I'm struggling to find somewhere to put the axle stand. I opted to remove the wheel, place it under the sill and then find somewhere suitable.
Therein lies the trouble. I couldn't even get the bloody wheel off! Undid the bolts no worries, but clearly they have never been greased or treated at any point, so are stuck solid to the hub.
Of course I really need them off, so I hit it with my biggest (rubber) hammer, but that didn't work.
So, DIY people of PH, how do I get it off when it's on the relatively unstable trolley jack? Any tips or tricks?

So, I found the crappy plastic jack point and got it in the air. The undercarriage is a vast display of plastic so I'm struggling to find somewhere to put the axle stand. I opted to remove the wheel, place it under the sill and then find somewhere suitable.
Therein lies the trouble. I couldn't even get the bloody wheel off! Undid the bolts no worries, but clearly they have never been greased or treated at any point, so are stuck solid to the hub.
Of course I really need them off, so I hit it with my biggest (rubber) hammer, but that didn't work.
So, DIY people of PH, how do I get it off when it's on the relatively unstable trolley jack? Any tips or tricks?

Adam_W said:
take all the bolts out, wind 2 or 3 back in a few turns then drop the car with the jack, ping 1 wheel released, jack back up and remove.
Hmmm. You will love this but I tried that!! Although I didn't take it all the way off the jack as I was worried about causing havoc. Might have another crack tomorrow then. How far would you drop the bolts back in? Just a quarter of the thread or so?
clarkey540i said:
Plastic hammer usually does it. Put a bit of copper grease on the mating surface once you've got them off and it won't happen again.
Is this the point where we get another numpty coming in and saying that the bolts dont hold the wheel on, its hub friction due to clamping force blah blah and whatever we do dont grease the mating surface?BMW's bloody awful for this. Probably because no-one can afford to maintain them 
I had mine over the pit, and used a hydraulic jack from the side of the pit to the side of the wheel. 6 tonnes did it in the end. Took me a few hours though. (Didn't think of the driving about idea, so I'm going to try that next time).

I had mine over the pit, and used a hydraulic jack from the side of the pit to the side of the wheel. 6 tonnes did it in the end. Took me a few hours though. (Didn't think of the driving about idea, so I'm going to try that next time).
I would go with loosening the bolts and going for a little drive. Your wheels wont fall off.
oh, and its not the job you want to do without the correct tools. Replacing rears is usually harder than fronts, and often you need a specialised tool to wind the rear hydraulics back in. Do you have that? Can be very tricky (but not impossible) without it.
oh, and its not the job you want to do without the correct tools. Replacing rears is usually harder than fronts, and often you need a specialised tool to wind the rear hydraulics back in. Do you have that? Can be very tricky (but not impossible) without it.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff




I did have an axle stand under there though, and I put a spare wheel under the car just in case. Probably not my smartest moment... 
k that.