How much brake binding is normal?
Discussion
Since I changed my front pads to proper OEM ones to eliminate the rattling from the cheap Pagid ones, I've noticed one of the wheels is binding slightly.
The wheel barely gets any warmer than the opposite one - perhaps a fraction. I only noticed it because the car seems to just about "stop itself" as you're crawling along and the car is stopping - I'm talking about speeds so slow that it's a lot slower than even walking pace, if that makes sense. There's a tiny jolt as the car comes to a final stop. Most people probably wouldn't notice.
But I'm anal. Should I have the lot apart again and make doubly sure everything's clean and operating freely?
It was fine with the old pads and they weren't that worn. The piston went back in nice and easily (so easily that I did it by hand) so I'm loathe to believe the caliper is sticking. But it probably is, knowing my luck.
The wheel can be turned no problem by hand but there is a small amount of resistance.
The wheel barely gets any warmer than the opposite one - perhaps a fraction. I only noticed it because the car seems to just about "stop itself" as you're crawling along and the car is stopping - I'm talking about speeds so slow that it's a lot slower than even walking pace, if that makes sense. There's a tiny jolt as the car comes to a final stop. Most people probably wouldn't notice.
But I'm anal. Should I have the lot apart again and make doubly sure everything's clean and operating freely?
It was fine with the old pads and they weren't that worn. The piston went back in nice and easily (so easily that I did it by hand) so I'm loathe to believe the caliper is sticking. But it probably is, knowing my luck.
The wheel can be turned no problem by hand but there is a small amount of resistance.
Howard- said:
Since I changed my front pads to proper OEM ones to eliminate the rattling from the cheap Pagid ones, I've noticed one of the wheels is binding slightly.
Sorry I can't help much with the actual question, but "cheap pagid ones"?Aren't they OEM suppliers to Aston Martin? They're certainly the most expensive pads and discs that I can buy from ECP for my Mondeo. I found that when I fitted Pagid to the rear and replaced the knackered old ones the rattling from my car stopped...
If it's sticking at all I'd think the caliper may need some attention though?
Gassing Station | General Gassing | Top of Page | What's New | My Stuff


