Aftermarket gauges, chavvy or savvy?
Aftermarket gauges, chavvy or savvy?
Author
Discussion

duffy78

Original Poster:

484 posts

170 months

Tuesday 30th April 2013
quotequote all
I had a low oil pressure warning on my car last year. Some post problem research revealed some inherent problems with the engine, ie oil sludge blocking the pick up pipe and the small amount of oil in the engine, 3.5l, meant I was very lucky to come away without any engine / turbo damage.

So I got the pickup changed, oil pump replaced, sump cleaned out and I then went on to clean / replace most of the breather and vacuum pipes to get rid of hopefully most of the sludge on there. Next on the list is to replace the turbo oil feed pipe just in case.

So that brings me to the original question, I'm thinking an aftermarket oil pressure gauge would be a worthwhile investment and while I'm at it why not a oil temp gauge as well. But would this be chavvy or savvy.

Something like this


pobox205

209 posts

163 months

Tuesday 30th April 2013
quotequote all
All depends on the car. The ones on the A pillars look awful.

storminnorman

2,357 posts

183 months

Tuesday 30th April 2013
quotequote all
I think what makes aftermarket mods 'chavvy' or crap is when they're pointless or nonfunctional.
You seem to have a perfectly good reason for needing one, it'll be functional and useful to the car, nor is it an irreversible modification. why not?

kambites

71,748 posts

252 months

Tuesday 30th April 2013
quotequote all
Sounds like a good idea if it serves a useful purpose, although it would probably look a bit daft.

Lefty

21,631 posts

233 months

Tuesday 30th April 2013
quotequote all
I think oil pressure and temp are vital, manifold pressure nice to have.

I agree that a-pillar gauges look st though. I've got a 3-gauge pod in my Impreza, above the centre console, replacing the top box and it looks like it could be oem.

CraigyMc

18,374 posts

267 months

Tuesday 30th April 2013
quotequote all
Chavtastrophe.

MC Bodge

30,206 posts

206 months

Tuesday 30th April 2013
quotequote all
I had some (Boost, analogue clock, oil temp) that fitted into a DIN slot (removed the cubby hole, shifted the radio down and fitted the gauges) in my (re-mapped, of course) Mk1 Octavia vRS. They blended-in quite well. I fitted the boost gauge after a couple of instances of boost drop in freezing weather.

Edited by MC Bodge on Tuesday 30th April 21:18

y2blade

56,325 posts

246 months

Tuesday 30th April 2013
quotequote all
pobox205 said:
The ones on the A pillars look awful.
This^^^
As nasty as Carbon look sticky film all over the interior.



rigga

8,808 posts

232 months

Tuesday 30th April 2013
quotequote all
Thing is a gauge is great if you look at it all the time, which when your driving you won't be,red warning lights , as used for low oil pressure work well because they grab your attention pretty quickly .....

duffy78

Original Poster:

484 posts

170 months

Tuesday 30th April 2013
quotequote all
This gubbins would replace the top shroud of the steering column. Apparently wont obscure any existing oem instruments.

I tend to associate stuff like this with people who mod there cars but it seems like with this particular engine when the low oil pressure warning light comes on it may already be too late.

I thought the temp gauge helps balance it out rather than having a single pod.

The engine is a vag 1.8t, well known for sludge issues. I think with the remedial work I've carried out it may be ok but the long term plan is to run this for a fair few years so I can build a westy or caterham.

Steve vRS

5,412 posts

272 months

Tuesday 30th April 2013
quotequote all
I had oil and boost pressure gauges in a Nomad A pillar gauge pod on my Bugeye Impreza WRX biggrin

I'll get my coat!

Steve

duffy78

Original Poster:

484 posts

170 months

Tuesday 30th April 2013
quotequote all
Oh and you can set a low pressure warning at whatever figure you like and the gauge lights up red. Few psi higher than oem and you're well forewarned.

Olly86

133 posts

170 months

Tuesday 30th April 2013
quotequote all
I had a duel water temp/oil pressure gauge fitted in my MK1 Focus RS as standard there is no gauge to show me if there was an issue or not, very worth while investment IMO. Also had an aftermarket boost gauge fitted as the standard gauge didn't go high enough once running more boost/power.

Have you thought about a Scangauge? Shows all sorts of info and plugs into the OBD2 port





Edited by Olly86 on Tuesday 30th April 22:00

FussyFez

972 posts

207 months

Tuesday 30th April 2013
quotequote all
Savvy. If you have a genuine need for it, then why not? I'm seriously considering a similar setup.

jds32

359 posts

178 months

Tuesday 30th April 2013
quotequote all
This gauge does oil temp / pressure plus one other temp of your choice. http://www.elise-shop.com/high-precision-60mm-oil-...

I'm not a big fan of those gauge pods that fit on top of the steering wheel cowl. Depending which 1.8t vag car you have different companies do gauge pods that fit in the space of the air vents that look a bit less in your face than the steering wheel ones.

Slow

6,973 posts

168 months

Tuesday 30th April 2013
quotequote all
My car has a aftermarket boost gauge, usefull but looks st where the old owner put it.

Put it down near the radio if you can.

Baryonyx

18,297 posts

190 months

Wednesday 1st May 2013
quotequote all
Definitely useful bits of kit. I find them best on the centre console or A pillar though. The A pillar is a good place for them as you can see them all the time and subconciously monitor them. I don't really like them behind the steering wheel but that's because they look 'cluttered' there.

Gad-Westy

16,666 posts

244 months

Wednesday 1st May 2013
quotequote all
jds32 said:
This gauge does oil temp / pressure plus one other temp of your choice. http://www.elise-shop.com/high-precision-60mm-oil-...

I'm not a big fan of those gauge pods that fit on top of the steering wheel cowl. Depending which 1.8t vag car you have different companies do gauge pods that fit in the space of the air vents that look a bit less in your face than the steering wheel ones.
Sorry to derail the thread a little here but would be interested to hear about the issues with the 1.8t engine and what the remedial work is. I'm thinking of getting another Golf 1.8t but the last one I had was near new so a bit out of touch with potential issues, other than the water pump made of cheese.

Back on topic, I'm in the camp of thinking that they rarely look good but that is clearly not your objective here so I'd say go for it if it's going to put your mind at ease.

duffy78

Original Poster:

484 posts

170 months

Wednesday 1st May 2013
quotequote all
Gad-Westy said:
Sorry to derail the thread a little here but would be interested to hear about the issues with the 1.8t engine and what the remedial work is. I'm thinking of getting another Golf 1.8t but the last one I had was near new so a bit out of touch with potential issues, other than the water pump made of cheese.

Back on topic, I'm in the camp of thinking that they rarely look good but that is clearly not your objective here so I'd say go for it if it's going to put your mind at ease.
Gad-Westy said:
Sorry to derail the thread a little here but would be interested to hear about the issues with the 1.8t engine and what the remedial work is. I'm thinking of getting another Golf 1.8t but the last one I had was near new so a bit out of touch with potential issues, other than the water pump made of cheese.

Back on topic, I'm in the camp of thinking that they rarely look good but that is clearly not your objective here so I'd say go for it if it's going to put your mind at ease.
It's well documented, just google 1.8t sludge. The way i understand it its a combination of the long life oil change schedule of services every two years instead of one and the relatively low oil capacity of the engine at approx 3.5l.

IIRC the turbo is both oil lubricated and cooled so When the engine is switched off and the oil pump stops whatever oil is in the turbo cooks, thickens and makes its way back into the sump via the oil return pipe. Over a two year service schedule carbon deposits eventually form and these in turn block the fine gauze in the oil pick up pipe in the sump leading to possibly catastrophic oil starvation.

Due to the low oil capacity this can happen very quickly, the cams sit direct on the head so they wear with no oil flow, the turbo can get starved of oil so that goes as well.

Another factor in all of this is that that crankcase breather pipes get sludged up. With the engine running if you find it hard to remove the oil filler cap then its likely the breather pipes are blocked. It's relatively cheap and easy to clean and replace the breather pipes and various breather valves but the front subframe has to be dropped to get the sump off and the oil pick up pipe replaced.

duffy78

Original Poster:

484 posts

170 months

Wednesday 1st May 2013
quotequote all
Yearly oil changes are essential on this engine. On top of all the remedial work I've done I've also fitted a slightly larger oil filter from a vw transporter. This holds an extra 0.5l of oil.