Understand electrics? then explain this...
Understand electrics? then explain this...
Author
Discussion

buzzer

Original Poster:

3,621 posts

271 months

Monday 12th August 2013
quotequote all
I have an LED bulb that I use as a lead light while working on the car. Its actually a stop light bulb so its the equivalent of 21w but obviously as its LED it draws much less current.

Its in a bulb holder and I have about 5 meters of cable on it and two crocodile clips, it really does make a great lead light, so much so, its the only one I use now.

Thing is, I normally use it connected to an old but good 12v battery...

When I went into the garage the other day I could see the bulb was flashing, about every 2 seconds... but when I looked, only the negative lead was connected? the other clip was on the bench. I picked the other lead up and it continued to flash. I then connected just the positive, no flash... reconnected just the negative, and it continued to flash...

how does it do that?

jon-

16,534 posts

247 months

Monday 12th August 2013
quotequote all

mygoldfishbowl

4,304 posts

174 months

Monday 12th August 2013
quotequote all
It's magic.

Toltec

7,179 posts

254 months

Monday 12th August 2013
quotequote all
It may be able to flash due to energy stored in the psu capacitors. The circuitry may also be reacting to a difference in the capacitance between having just the negative or positive leads connected.

The Moose

23,710 posts

240 months

Monday 12th August 2013
quotequote all
mygoldfishbowl said:
It's magic.
To be honest, I think this is the answer... wink

Dr Doofenshmirtz

16,952 posts

231 months

Monday 12th August 2013
quotequote all
Have you been drinking or taking any 'substances' ?

Toltec said:
It may be able to flash due to energy stored in the psu capacitors. The circuitry may also be reacting to a difference in the capacitance between having just the negative or positive leads connected.
You as well?

Ozzie Osmond

21,189 posts

277 months

Monday 12th August 2013
quotequote all
IF there is a capacitor around that is the most likely source. Perhaps earth leakage in your damp garage allows slow charge of the capacitor.

When the capacitor acts as the power source, it dumps its voltage much quicker than a battery so the LED is on only for a short period of time. LEDs have a "strike" voltage and until that point is reached it may provide sufficient resistance to allow the capacitor to charge a little rather than all the energy just leaking away immediately through the diode (as it would through a conventional light bulb).

No capacitor = no clue! OzOs

buzzer

Original Poster:

3,621 posts

271 months

Monday 12th August 2013
quotequote all
I think its magic....

its been flashing for hours... so I cant see that its stored energy in a capacitor...

The garage is not damp at all (central heating in there!)


Krikkit

27,943 posts

212 months

Monday 12th August 2013
quotequote all
Forgive me, but if it's in a simple bulb holder there's no capacitor in the system.

If the LED is flashing it would indicate that you're getting a voltage build-up within the lead that connects battery to LED, once it reaches the breakdown voltage of the LED (which could be anything from 1.5V to 12V), the current will flow and discharge into the bench/world.

Any powerful magnetic devices about?

Toltec

7,179 posts

254 months

Monday 12th August 2013
quotequote all
Krikkit said:
Forgive me, but if it's in a simple bulb holder there's no capacitor in the system.
Yes there are, the leds will be driven by a power supply built into the lamp.

Garlick

40,601 posts

271 months

Monday 12th August 2013
quotequote all
Call Derek Acorah

Mr2Mike

20,143 posts

286 months

Monday 12th August 2013
quotequote all
Toltec said:
Yes there are, the leds will be driven by a power supply built into the lamp.
Very unlikely. The "power supply" consists of a current limiting resistor(s) in the majority of these LED automotive lamps.

Charlie Michael

2,753 posts

215 months

Monday 12th August 2013
quotequote all
Garlick said:
Call Derek Acorah
hehe

anonymous-user

85 months

Monday 12th August 2013
quotequote all
Garlick said:
Call Derek Acorah
And tell him he's a tit........... ;-)

cuprabob

19,971 posts

245 months

Monday 12th August 2013
quotequote all
Max_Torque said:
And tell him he's a tit........... ;-)
He won't see that coming...

Mr2Mike

20,143 posts

286 months

Monday 12th August 2013
quotequote all
Ozzie Osmond said:
LEDs have a "strike" voltage and until that point is reached it may provide sufficient resistance to allow the capacitor to charge a little rather than all the energy just leaking away immediately through the diode (as it would through a conventional light bulb).
LEDs do not have a 'strike' voltage in the same way that a neon or fluorescent tube has i.e. it's forward voltage does not drop when it illuminates, but rather it's forward voltage simply increases with current. As soon as the voltage rises high enough to start conduction, any charge will just bleed away.

You can make a very simple flashing lamp by connecting a neon across a capacitor, and it can be powered by simply grounding one side and bringing the other wire close to an air ionizer, or something charged with static. You couldn't do this with an LED though.

OP, just to clarify, are you using one of the LED replacement lamps available on e.g. eBay that consists of numerous small LEDs connected up to a standard filament lamp base? example

Liquid Tuna

1,403 posts

187 months

Monday 12th August 2013
quotequote all
Do you live under a pylon?

Ozzie Osmond

21,189 posts

277 months

Monday 12th August 2013
quotequote all
Liquid Tuna said:
Do you live under a pylon?
Interesting thought!

For those who are unaware,
  • Take a normal 6 foot fluorescent tube
  • Find some high tension electricity pylons and cables
  • Stand the tube vertically with one end in the ground and

Bohally

943 posts

178 months

Monday 12th August 2013
quotequote all
Ozzie Osmond said:
Interesting thought!

For those who are unaware,
  • Take a normal 6 foot fluorescent tube
  • Find some high tension electricity pylons and cables
  • Stand the tube vertically with one end in the ground and
That looks awesome. I'd be st scared I ended up getting fried somehow!

Impasse

15,099 posts

272 months

Monday 12th August 2013
quotequote all
Is the flex to the lamp coiled up?