worse or better mpg?
Discussion
Wouldn't a modern car have a temperature sensor on the intake manifold which would measure intake air temperature, calculate the mass accordingly and hence not make any difference to the fuel economy? I would have thought that this was the case, and the cold air feed would only be there to allow colder (denser, heavier) air in to allow more power if need be?
I may be wrong. Others know more than me ...
Oli.
I may be wrong. Others know more than me ...
Oli.
zcacogp said:
Wouldn't a modern car have a temperature sensor on the intake manifold which would measure intake air temperature, calculate the mass accordingly and hence not make any difference to the fuel economy? I would have thought that this was the case, and the cold air feed would only be there to allow colder (denser, heavier) air in to allow more power if need be?
I may be wrong. Others know more than me ...
Oli.
I thought the whole point of a mass airflow sensor was to measure the mass of the airflow. I may be wrong. Others know more than me ...
Oli.

kambites said:
zcacogp said:
Wouldn't a modern car have a temperature sensor on the intake manifold which would measure intake air temperature, calculate the mass accordingly and hence not make any difference to the fuel economy? I would have thought that this was the case, and the cold air feed would only be there to allow colder (denser, heavier) air in to allow more power if need be?
I may be wrong. Others know more than me ...
Oli.
I thought the whole point of a mass airflow sensor was to measure the mass of the airflow. I may be wrong. Others know more than me ...
Oli.

kambites said:
zcacogp said:
Wouldn't a modern car have a temperature sensor on the intake manifold which would measure intake air temperature, calculate the mass accordingly and hence not make any difference to the fuel economy? I would have thought that this was the case, and the cold air feed would only be there to allow colder (denser, heavier) air in to allow more power if need be?
I may be wrong. Others know more than me ...
Oli.
I thought the whole point of a mass airflow sensor was to measure the mass of the airflow. I may be wrong. Others know more than me ...
Oli.

Either way, the mass (however derived) is the critical value and not temperature. Hence, as long as your mass calculation is done correctly then temperature makes no difference.
Oli.
kambites said:
I thought the whole point of a mass airflow sensor was to measure the mass of the airflow. 
Not if its speed density using MAP and engine speed as primary load sites. Nothing stopping intake temp offering correction to throttle tip in transients either regardless of load method.
JonnyVTEC said:
Prof Prolapse said:
1) No, warm air will not help economy as it's less dense.
Which you mean you need more throttle for the same power and hence it reduces pumping losses and the warmer air means the fuel droplets are more likely to offer complete combustion...This will help economy.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff


