VERY slow puncture, permmanent repair options...
VERY slow puncture, permmanent repair options...
Author
Discussion

jimbobsimmonds

Original Poster:

1,824 posts

196 months

Tuesday 20th August 2013
quotequote all
Hi all. I know this has been asked before (probably) but I am going to ask it anyway. How do I find the cause of, and then repair, a slow puncture that I seem to have.

The tyre is an Eagle F1 Assy 2 and is less than 3 months (2000 miles) old. It seems to be deflating to 20 psi over the course of a few days, and interestingly, not deflating any more.

What could be causing this. Obviously a pin prick hole but wouldn't it go completely flat? Could a leaky valve be the issue? Do valves even leak and can they be replaced?

Erm, so basically, what I'm asking is, if you were me what would you do? (I'm not rich yet so would prefer not to buy another tyre!)

P.S: Apologies in advance for the spelling mistake in the title. It's really hard to keep one's spelling accurate while using their touchscreen phone while driving at excessive speed around the local industrial estate/orphanage for deaf children...


Cheers
Jimbob

Dave^

7,903 posts

284 months

Tuesday 20th August 2013
quotequote all
I would definitely ask lots of people who haven't and won't see it, rather than going to a local tyre place and asking them to have a look...

Zato

330 posts

212 months

Tuesday 20th August 2013
quotequote all
I had a slow puncture on a new X5 tyre. Local tyre shop put the wheel in a bath to locate the nail and then removed the nail, drilled the hole bigger and inserted a mushroom from the inside out using glue. 10 minutes later off i go £20 lighter.

Very easy and if valve it will just be changed.

Zato

330 posts

212 months

Tuesday 20th August 2013
quotequote all
Dave^ said:
I would definitely ask lots of people who haven't and won't see it, rather than going to a local tyre place and asking them to have a look...
The man is seeking advice. Sure your response is really helpfull.

RDB

334 posts

210 months

Tuesday 20th August 2013
quotequote all
I would take it to the place that fitted the tyres and ask them to check it.

I sorted one out for a friend recently that turned out to be light corrosion on the wheel rim that had prevented the tyre bead sealing properly. The tyre fitter took the tyre off and sanded the rim a bit, then refitted it and checked it again. I think it cost about £20 and has been fine since.

Cupramax

11,007 posts

283 months

Tuesday 20th August 2013
quotequote all
Zato said:
The man is seeking advice. Sure your response is really helpfull.
The man is asking the blatantly obvious and unanswerable without seeing the tyre damage...

Take it to a tyre shop.

stick100

7,017 posts

199 months

Tuesday 20th August 2013
quotequote all
If its a alloy wheel 9 times out of ten its leaking round the rim it needs the flaking powder coat taking of round where the bead seats

KTF

10,720 posts

181 months

Tuesday 20th August 2013
quotequote all
Dave^ said:
I would definitely ask lots of people who haven't and won't see it, rather than going to a local tyre place and asking them to have a look...
I like this smile

Hoofy

80,180 posts

313 months

Tuesday 20th August 2013
quotequote all
Had similar on a new tyre. Just needed regreasing/sealing(whatever they call it) and being put back on the alloy.

jimbobsimmonds

Original Poster:

1,824 posts

196 months

Tuesday 20th August 2013
quotequote all
2 things to note...

I was planning on taking it to the tyre place but seeing as I will be working 11 hour days and weekends it makes that a little tricky in the next week or so.

I won't ask a silly car related question on PH again...

OllieJT

84 posts

165 months

Wednesday 21st August 2013
quotequote all
I work in a garage myself and have to say, when we change a tyre, we clean the edge of the rim to stop this happening. Id get that checked

MGJohn

10,203 posts

214 months

Wednesday 21st August 2013
quotequote all
stick100 said:
If its a alloy wheel 9 times out of ten its leaking round the rim it needs the flaking powder coat taking of round where the bead seats
Yes, agreed. That is my experience over the years particularly if when a tyre was fitted in the past those clip-on balance weights were hammered into the rim edges. Thus destroying the unseen protective paint covering on the tyre-rim seal interface. Rain and winter road salt then attacks the metal where scratched and the corrosion spreads further destroying the air pressure seal.

Lost count of the times I've had slow punctures in good condition Alloy Wheels which have been damaged by heavy handed rim clip balance weight fitting.

Using a cheap plastic Mist Sprayer ( Garden Centres for about two quid ) with a 10-1 diluted Washing Up Liquid mix, I spray the whole tyre making sure the tyre-rim interface gets a good soaking. Any escaping air pressure in damaged interface areas will soon produce tell tale air bubbles in the soapy spray :~

Rim clip weights removed. You can see where they were :~





New unused Factory spare ... MG Guilty! frown



Extreme cases :~



After removal of the tyre and balance weight clips :~



Some outfits use sealant to "seal" the damaged interface. Rarely lasts :~



Having tyres removed, I then rub down smoothing the corroded interface areas with various grades or sand or wet and dry paper. Hand painted the unseen area after treatment with suitable silver paint. Allow to harden off for a day or so. Then take the wheel and tyre and have them refitted and balanced ... insisting that SELF-ADHESIVE balance weights are used and never rim clip versions which always damage the protective paint and soft alloy no matter how careful they are fitted. Usually hammered on quickly as I have seen in places where some folks confuse uncaring speed with a job well done.

Those damaged alloy wheel rims I repaired all hold pressure as good as new.

By the way, I used City Powder Coaters in Birmingham a couple of years back to refurbish two sets of 17" Rover Vitesse Alloys on my son's and my own 620ti. Not expensive and still looking good. Not bad for wheels close to sixteen years old :~