The spark plug challenge..
Discussion
Recently picked up a 3.0 petrol Shogun Sport from a friend and noticed that the 6 plugs are...... rather buried!
After some Googling, it seems quite common for a garage to quote 1.5 hours to do the job and you can expect to lose 2 to 3 hours under the bonnet for a reasonably well-equipped home mechanic!
Every car I have owned / worked on has taken me five to ten minutes (or less) to change a set of plugs, so it left me wondering if there are any cars out there worse than this for a plug change, or is this some sort of record?
Any horror stories out there in PH land?
After some Googling, it seems quite common for a garage to quote 1.5 hours to do the job and you can expect to lose 2 to 3 hours under the bonnet for a reasonably well-equipped home mechanic!
Every car I have owned / worked on has taken me five to ten minutes (or less) to change a set of plugs, so it left me wondering if there are any cars out there worse than this for a plug change, or is this some sort of record?
Any horror stories out there in PH land?

Digby said:
I feel better already 
Apparently it's wise to spend a few quid and use something like NGK platinums as they tend to last 50k +, although on the NGK web page, it suggests Laser Iridium plugs will last even longer.
I think the TypeR plugs last 60k, they are more expensive than a standard interval plug but that sorta balances out due to the change interval.
Apparently it's wise to spend a few quid and use something like NGK platinums as they tend to last 50k +, although on the NGK web page, it suggests Laser Iridium plugs will last even longer.
We swapped them out on a mates car a few weeks ago, a good service made a lot of difference, I was surprised.
Smart car, remove rear bumper and crash structure then use a special tool to remove the 3 rear plug leads (6 plugs in the 3cyl engine), not a great amount of time compaired to a V12 jag i'll admit but convoluted non the less or golf FSI= remove the inlet maniifold to acess the middle 2 plugs ?
The Alfa V6 in my 166 is a bit of a sod. The front three aren't too bad, just a load of allen-head bolts to remove the cover, more bolts to remove the coils and then a long-reach extension to get too the plugs.
The rear bank is the same, but also involves removing the entire inlet tract, throttle arrangement, plenum chamber and a whole heap of pipes/cables/etc from the back of the head.
I seem to remember a friend who had a sporty Renault 5 (Gordini Mk1 I think) said that the windscreen had to be removed to get to the rearmost plug.
The rear bank is the same, but also involves removing the entire inlet tract, throttle arrangement, plenum chamber and a whole heap of pipes/cables/etc from the back of the head.
I seem to remember a friend who had a sporty Renault 5 (Gordini Mk1 I think) said that the windscreen had to be removed to get to the rearmost plug.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff



t of a job on a Honda Civic Type R - the FN2 version, you need to take a fair bit of trim off to get at them, but at least the change intervals are fairly lengthy.
