Halfords Trolley Jack- loses height over time
Discussion
Bought it in the sales but only just used it for the first time. It gets the rear of the car up nicely and I put some axle stands underneath. Next morning the trolley jack's lifter was right at the bottom.
Do I need more hydraulic fluid or do I need to bleed out the air? It drops even without weight on it over time.
Any help appreciated. Cheers
I'm replacing lower control arms on the rear in case you wanted to know
Do I need more hydraulic fluid or do I need to bleed out the air? It drops even without weight on it over time.
Any help appreciated. Cheers
I'm replacing lower control arms on the rear in case you wanted to know

You shouldn't NEED to leave it extended for any period, since you shouldn't be using the jack to support, only to lift. But it's very likely the drop screw isn't sealing properly. If it were the seals in the ram, you'd be losing fluid onto the floor.
Take it back, get your money back, go to http://www.sgs-engineering.com/hydraulic-jacks/tro...
Take it back, get your money back, go to http://www.sgs-engineering.com/hydraulic-jacks/tro...
mwstewart said:
You shouldn't rely on a jack to do this. A lot of them will go down overnight.
He's already said he uses axle stands, the jack is descending without any load on it 
OP, if the release valve is tight and it's still going down, take it back. I gather they're usually pretty good about exchanges.
PoleDriver said:
The first rule about buying stuff from Halfrauds is... Don't buy stuff from Halfrauds!
Not really. They sell some of the best value DIYers' tools on the market. My socket set has had the best part of fifteen years of fairly heavy DY use and is still immaculate; it only cost about £40. TooMany2cvs said:
You shouldn't NEED to leave it extended for any period, since you shouldn't be using the jack to support, only to lift. But it's very likely the drop screw isn't sealing properly. If it were the seals in the ram, you'd be losing fluid onto the floor.
Take it back, get your money back, go to http://www.sgs-engineering.com/hydraulic-jacks/tro...
I bought one from SGS and it went down on load by 25mm in about 5 minutes. They were good about replacing it though and the new one is pretty good - not perfect, but good. Most will sink slowly, as already said. The problem is that most cars have one jacking point per 'corner' and there's nowhere officially approved to put an axle stand except where the jack already is.Take it back, get your money back, go to http://www.sgs-engineering.com/hydraulic-jacks/tro...
Gassing Station | General Gassing | Top of Page | What's New | My Stuff



ked take it back.
I am using axle stands.