How much will this cost?
How much will this cost?
Author
Discussion

t4thomas

Original Poster:

394 posts

197 months

Friday 10th April 2015
quotequote all
1994 Peugeot 106

Needs head gasket + skimmed head + cambelt + water pump.

What's the damage?

Hooli

32,278 posts

231 months

Friday 10th April 2015
quotequote all
£700 As a guess based on a fiesta costing £500 without the waterpump n skim.

SirSquidalot

4,067 posts

196 months

Friday 10th April 2015
quotequote all
About £600-700

SuperPav

1,360 posts

156 months

Friday 10th April 2015
quotequote all
t4thomas said:
1994 Peugeot 106

Needs head gasket + skimmed head + cambelt + water pump.

What's the damage?
The car? Or to fix it?

The car would be worth £100.

Fixing it would cost about £500.

With it fixed, the car would be worth about £500.

DeuxCentCinq

14,180 posts

213 months

Friday 10th April 2015
quotequote all
As it's a 106 Rallye he's asking about, it would be easier and cheaper (although sacrilege imo) to just get an engine from a Saxo VTR in there. Or even go 16v from a VTS or 106 GTi.

t4thomas

Original Poster:

394 posts

197 months

Friday 10th April 2015
quotequote all
Ok, thanks gents. This all sounds ok to me.

If I can get the lot done for £700 or less, I'll be happy as a pig in...

t4thomas

Original Poster:

394 posts

197 months

Friday 10th April 2015
quotequote all
DeuxCentCinq said:
As it's a 106 Rallye he's asking about, it would be easier and cheaper (although sacrilege imo) to just get an engine from a Saxo VTR in there. Or even go 16v from a VTS or 106 GTi.
NO WAY! This example is totally original!

Krikkit

27,943 posts

212 months

Friday 10th April 2015
quotequote all
These engines are a doddle to dismantle, cambelt and water pump are less than an hour's job. £700 is far too much imo, if you were closer I'd do it for beers!

SuperPav

1,360 posts

156 months

Friday 10th April 2015
quotequote all
Krikkit said:
These engines are a doddle to dismantle, cambelt and water pump are less than an hour's job. £700 is far too much imo, if you were closer I'd do it for beers!
Agreed.

Also, ignore my previous valuation of car if it's a Rallye biggrin

rallycross

13,763 posts

268 months

Friday 10th April 2015
quotequote all
t4thomas said:
1994 Peugeot 106 Rallye

Needs head gasket £20
skimmed head £45
cambelt + water pump £60

labour - depends who does it but somewhere between £150 and £300.

It takes less than an hour to get the head off one of these cars.

While the head is off getting skimmed it will be worth getting the valves/seats checked, get them lapped back in and it will run better.

?

t4thomas

Original Poster:

394 posts

197 months

Friday 10th April 2015
quotequote all
rallycross said:
I'll see what I can do!

t4thomas

Original Poster:

394 posts

197 months

Friday 10th April 2015
quotequote all
SuperPav said:
Agreed.

Also, ignore my previous valuation of car if it's a Rallye biggrin
Thanks SuperPav.

There seems to be pretty strong prices for Rallye's at the moment, particularly the S1. It's just a shame that good examples are so hard to come by.

aka_kerrly

12,506 posts

241 months

Friday 10th April 2015
quotequote all
t4thomas said:
DeuxCentCinq said:
As it's a 106 Rallye he's asking about, it would be easier and cheaper (although sacrilege imo) to just get an engine from a Saxo VTR in there. Or even go 16v from a VTS or 106 GTi.
NO WAY! This example is totally original!
clap

that is the correct answer.

What are you hoping to achieve ? is the engine rebuild following a dead head gasket? If the car is a long term keeper then perhaps upping the budget for some head work and ARB bolts could yield a performance increase and reduce costs in the future should the head need to come off again*

  • based on a mate whose 106 Rallye ate 3 head gaskets in 2 years. Make sure the head is pressure tested and carefully inspect the water jackets in the block to ensure no cracks.

t4thomas

Original Poster:

394 posts

197 months

Friday 10th April 2015
quotequote all
Thanks.

The car is still running without any performance problems, but there is a leaky head gasket.

It's only done 88K miles and has a good amount of history; The issue is that I can't find any evidence of a cambelt / water pump change, so don't believe this has been done.

The interior is immaculate and whilst the bodywork needs some tidying, there's no significant rust issues etc. to address. I'm just looking to restore the car to it's former glory so that I can enjoy it on high days and dry days.

It's not an investment, but I wouldn't be surprised if I broke even at some point.

BritishRacinGrin

26,714 posts

191 months

Friday 10th April 2015
quotequote all
Seriously easy job. I'd do it for fun. Probably closer to £300 than £400 IMO.

t4thomas

Original Poster:

394 posts

197 months

Friday 10th April 2015
quotequote all
BritishRacinGrin said:
Seriously easy job. I'd do it for fun. Probably closer to £300 than £400 IMO.
Where you based... Is that a quote! wink

Vaud

60,050 posts

186 months

Friday 10th April 2015
quotequote all
Great car, full PH points for wanting to keep it standard.

t4thomas

Original Poster:

394 posts

197 months

Friday 10th April 2015
quotequote all
Vaud said:
Great car, full PH points for wanting to keep it standard.
Thanks.

I am a sucker for rattly french stuff.

Axionknight

8,505 posts

166 months

Friday 10th April 2015
quotequote all
t4thomas said:
NO WAY! This example is totally original!
It came out of the factory with a shagged engine?

BritishRacinGrin

26,714 posts

191 months

Saturday 11th April 2015
quotequote all
t4thomas said:
BritishRacinGrin said:
Seriously easy job. I'd do it for fun. Probably closer to £300 than £400 IMO.
Where you based... Is that a quote! wink
Maybe under-selling myself a little there... Have you considered DIY? I've only ever done two head gaskets but both were successful and I found it easy. Fun, even.

Bring the car, my tools and a bootful of proper ale to Thailand and I'll get cracking.