Rev & Go Karts - Not Going !
Rev & Go Karts - Not Going !
Author
Discussion

V8RX7

Original Poster:

28,982 posts

294 months

Sunday 12th April 2015
quotequote all
I have a couple of cheap rev and go karts (bought secondhand) for my kids.

When they tried them last year they worked ok.

This year both started.

One ran fine for 20mins then started to loose power - I left it to cool but it now turns over but won't start and doesn't disengage the clutch.

The other wouldn't disengage the clutch but if I lifted the rear wheels off the ground it would start and with a push it would go. However it didn't have the power to go with anyone in it - it just died and then refused to start and only turns over slowly (even on a jump pack).

So baring in mind these are "no name" karts is it worth looking to fix them or should I just drop new engines in them.

Can anyone recommend an engine supplier ?

Mr2Mike

20,143 posts

286 months

Sunday 12th April 2015
quotequote all
Presumably you mean the clutch won't engage, i.e. revving the engine produces to movement?

As they have been standing then it's likely the carbs have gummed up and they are now running very lean. If these are two stroke engine, then the sudden power loss may have been the engine starting to seize.

Ozone

3,112 posts

218 months

Sunday 12th April 2015
quotequote all
This may sound stupid but I had this with my sons cheap petrol kart. It ran for a while then stopped and wouldn't restart, I had left the choke on and the spark plug needed cleaning to get it going again redfacepaperbag

anonymous-user

85 months

Sunday 12th April 2015
quotequote all
Just sounds like the clutches are knackered. Assume they are four stroke, pull start engines in which case they don't need much maintenance but don't like being sat still for months without turning.

Hunt around for the Honda GX160 engine, it's the standard for rental karts. Bombproof and pretty cheap, it's used in loads of industrial machines too. You should be able to pick them up secondhand from www.karting.co.uk or www.karting1.co.uk

Edited by anonymous-user on Sunday 12th April 18:53

V8RX7

Original Poster:

28,982 posts

294 months

Sunday 12th April 2015
quotequote all
Mr2Mike said:
If these are two stroke engine, then the sudden power loss may have been the engine starting to seize.
BUGGERATION !

Despite running my chainsaws at the same time as the kids were buzzing around on these I completely forgot they were two stroke and didn't put any oil in the fuel.

Well that's solved that mystery on the one but the other didn't work from the offset.

Never having played with Auto clutches how do they work ? I thought the karts freewheeled when I pushed them into the garage last year and now I have to lift the rears up as the engine doesn't disengage from the wheels.

gazz81

172 posts

163 months

Sunday 12th April 2015
quotequote all
Put up a pic of the engines, will be interesting to see them. But as said, the gx160 engine is a good choice.

anonymous-user

85 months

Sunday 12th April 2015
quotequote all
Ok if they are two stroke, it probably won't start because the mixture is too lean or too rich, you can buy aerosol squirts Magic start stuff that you fire through the carb when you start it and it works, then just turn the needle to get it running better. Check the carb jet is suited to the conditions and oil/petrol mixture too. I used 1:50 which works fine and cheap 95ron is best

Not being funny but are you sure they are clutched? I'd guess they are old BT82s or similar 100cc air cooled two strokes with clutches but they still change hands for good money.

Edited by anonymous-user on Sunday 12th April 18:58

Mr2Mike

20,143 posts

286 months

Sunday 12th April 2015
quotequote all
V8RX7 said:
BUGGERATION !

Despite running my chainsaws at the same time as the kids were buzzing around on these I completely forgot they were two stroke and didn't put any oil in the fuel.

Well that's solved that mystery on the one but the other didn't work from the offset.

Never having played with Auto clutches how do they work ? I thought the karts freewheeled when I pushed them into the garage last year and now I have to lift the rears up as the engine doesn't disengage from the wheels.
I suspect they will be centrifugal clutches. The most basic ones look a bit like a drum brake inside, the shoes are pivoted at one end and have a spring at the other to hold them in. As the clutch spins faster, the shoes fly out and start gripping the drum. Other types use rollers or ball bearings that are forced outwards and engage a more conventional multi-plate clutch (scooters/mopeds use these system).

myvision

2,132 posts

167 months

Sunday 12th April 2015
quotequote all
Do the engines look like this?