Diagnosing faults with OBD2 fault code and freeze frame data
Discussion
My car has an irritating issue. It goes into safe mode when doing motorways.
How long it takes to do this is unpredictable (sometimes as short as 10 minutes of motorway, sometimes it will do hours).
As a result - its hard to know a particular remedial action has been effective without clogging it up and down a motorway until it does it again. Most garages will test drive a car for 10/15 minutes, this problem can take hours to occur.
I have a shedload of captured fault data (pending and confirmed codes)
I have a shedload of 'freeze frame' data (I understand my ECU captures the exact conditions of the engine when it makes a fault code permanent).
I have lots of OBD data traces (all PIDs the ECU will let me log) with this incident occuring. Nothing looks out of whack (to my untrained eye)
The underlying theme is "random multiple misfires".
I've seen confirmed and pending codes across all cylinders.
This kind of rules out a single problematic cylinder/injector/coil pack.
I've had leaks in the exhaust sorted.
I've had replacement AFRs.
I've tried an identical, (but someone elses) ECU.
I've had the intake and exhaust smoke tested - no leaks.
The problem was improved by fixing the leaks in the exhaust, no real surprise there, but its still there.
New MAF sensor will be going in soon.
Can anyone recommend to me a firm who can genuinely make sense of fault code and freezeframe data to good effect (as opposed to just arbitrarily checking and replacing components that might provoke a misfire if not working).
Gavin.
How long it takes to do this is unpredictable (sometimes as short as 10 minutes of motorway, sometimes it will do hours).
As a result - its hard to know a particular remedial action has been effective without clogging it up and down a motorway until it does it again. Most garages will test drive a car for 10/15 minutes, this problem can take hours to occur.
I have a shedload of captured fault data (pending and confirmed codes)
I have a shedload of 'freeze frame' data (I understand my ECU captures the exact conditions of the engine when it makes a fault code permanent).
I have lots of OBD data traces (all PIDs the ECU will let me log) with this incident occuring. Nothing looks out of whack (to my untrained eye)
The underlying theme is "random multiple misfires".
I've seen confirmed and pending codes across all cylinders.
This kind of rules out a single problematic cylinder/injector/coil pack.
I've had leaks in the exhaust sorted.
I've had replacement AFRs.
I've tried an identical, (but someone elses) ECU.
I've had the intake and exhaust smoke tested - no leaks.
The problem was improved by fixing the leaks in the exhaust, no real surprise there, but its still there.
New MAF sensor will be going in soon.
Can anyone recommend to me a firm who can genuinely make sense of fault code and freezeframe data to good effect (as opposed to just arbitrarily checking and replacing components that might provoke a misfire if not working).
Gavin.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff


