Comfiest sportyish seats
Discussion
kambites said:
You'd need to check it's actually viable at all. It's tricky swapping seats around on a modern car because they almost always contain airbags and removing air bags can have implications for road legality these days.
ThisUsually overcome with some resistors, however that'll be a loophole closed quickly
mat205125 said:
kambites said:
You'd need to check it's actually viable at all. It's tricky swapping seats around on a modern car because they almost always contain airbags and removing air bags can have implications for road legality these days.
ThisUsually overcome with some resistors, however that'll be a loophole closed quickly
LankyFreak said:
kambites said:
You'd need to check it's actually viable at all. It's tricky swapping seats around on a modern car because they almost always contain airbags and removing air bags can have implications for road legality these days.
doesn't have side or seat airbags as it is old 
Also R129 gen SL, a bit heavy but you do get electrics and a built in seat belt.
Edited by PositronicRay on Thursday 3rd February 13:31
LankyFreak said:
kambites said:
You'd need to check it's actually viable at all. It's tricky swapping seats around on a modern car because they almost always contain airbags and removing air bags can have implications for road legality these days.
doesn't have side or seat airbags as it is old 

Bear in mind, will almost certainly involve drilling of the floorpan unless (perhaps) same make. And assuming there is an appropriate flat area for the new rails to sit in, otherwise things get complicated very quickly. And that nothing fouls the free movement of the new seat, and that it physically fits, as they are often tight up against the transmission tunnel. And when you drill, do check that it's just the floorpan drilled, not something pesky like a brake line. Recommend you obtain on a fully refundable basis in case you don't get them to work. It's not impossible or very difficult, but it's not like replacing your favourite armchair.
996TT02 said:
Bear in mind, will almost certainly involve drilling of the floorpan unless (perhaps) same make. And assuming there is an appropriate flat area for the new rails to sit in, otherwise things get complicated very quickly. And that nothing fouls the free movement of the new seat, and that it physically fits, as they are often tight up against the transmission tunnel. And when you drill, do check that it's just the floorpan drilled, not something pesky like a brake line. Recommend you obtain on a fully refundable basis in case you don't get them to work. It's not impossible or very difficult, but it's not like replacing your favourite armchair.
should work out okay, I'll be measuring everything a lot before purchase.Gassing Station | General Gassing | Top of Page | What's New | My Stuff



