RE: Car Depreciates By £630 Per Mile
Tuesday 16th October 2007
Commissioned by a wealthy enthusiast, it took eight skilled Aston Martin Lagonda craftsmen two years to design and three years to construct. The car used modern technology but with classically inspired coachwork design finished in two-tone Burgundy and Champagne.
The ‘gullwing’ rear doors led to an air-conditioned passenger cabin, finished in Champagne leather with rosewood trim and black leather. The radiator badge, produced by Garrards, the royal jeweller, was in gold and black enamel.
As a true one-off, the Buckingham has sold at auction for £28,000 – meaning it had cost over £630 per mile in depreciation alone.
Car Depreciates By £630 Per Mile
And someone has just snapped it up.
The motor was a 1985 Buckingham which cost around £250,000 to build and had covered just 348 miles in the past 22 years.
Commissioned by a wealthy enthusiast, it took eight skilled Aston Martin Lagonda craftsmen two years to design and three years to construct. The car used modern technology but with classically inspired coachwork design finished in two-tone Burgundy and Champagne.
The ‘gullwing’ rear doors led to an air-conditioned passenger cabin, finished in Champagne leather with rosewood trim and black leather. The radiator badge, produced by Garrards, the royal jeweller, was in gold and black enamel.
As a true one-off, the Buckingham has sold at auction for £28,000 – meaning it had cost over £630 per mile in depreciation alone.
Discussion
The Original Advert
The car for sale for a good couple of years, with the same dealer.
I guess a one off car has a limited customer base
Darren
The car for sale for a good couple of years, with the same dealer.
I guess a one off car has a limited customer base

Darren
thefrog said:
Well, I wouldn't like to be a "skilled Aston Martin Lagonda craftsman" on the wages the numbers suggest...
£250,000 / 8 craftsmen / 5 years = £6,250 per year, and that's assuming parts were free !!!
These were late 1970's - 1980's salaries. I'd say that was quite reasonable back then!£250,000 / 8 craftsmen / 5 years = £6,250 per year, and that's assuming parts were free !!!
88v8 said:
Good try, but like many 'vintage' replicas, the proportions are wrong because the wheel diameter is too small. This needs at least 18" or 19" wheels, and not with low-profiles.
I disagree, go for polished rims with low-profiles, then you could go straight to Sean Pee Diddly or whoever and flog as an 'Aston' more exclusive than a Bentley. Bling Bling loads more wonga 
Gassing Station | General Gassing | Top of Page | What's New | My Stuff








