Problem with changing car battery
Problem with changing car battery
Author
Discussion

entropy

Original Poster:

6,441 posts

232 months

Wednesday 13th April 2011
quotequote all
After a lot of huff & puff I managed to change the battery in 52-reg Corsa but on my first attempt I ripped out bits of plastic which turned out to be shield/rain guard thingy. Very worried about water entering since the battery sits underneath the windscreen and plastic splash tray/grille/venting - help!

XG332

3,927 posts

217 months

Wednesday 13th April 2011
quotequote all
Just give the battery terminals a good coat of vasaline to stop any corrosion.

entropy

Original Poster:

6,441 posts

232 months

Wednesday 13th April 2011
quotequote all
How regularly will I need to check and re-grease?

Every 6 months?

McSam

6,753 posts

204 months

Wednesday 13th April 2011
quotequote all
entropy said:
How regularly will I need to check and re-grease?



Every 6 months?
Probably not even that, but whenever you're under the bonnet give it a quick look. Grease will stay there for ages and you should have no problems. Just keep an eye on other stuff that might have been protected by that guard, but.. Stuff under there is usually designed to be able to get wet!

Glassman

24,953 posts

244 months

Saturday 16th April 2011
quotequote all
entropy said:
After a lot of huff & puff I managed to change the battery in 52-reg Corsa but on my first attempt I ripped out bits of plastic which turned out to be shield/rain guard thingy. Very worried about water entering since the battery sits underneath the windscreen and plastic splash tray/grille/venting - help!
Your Corsa windscreen is glazed directly to the car (bonded). The cured Polyurethane cannot be disturbed or damaged by removing the plastic cowl.

Be sure to check the plastic trim is in place under the bottom of the screen before you offer the cowl back up.



entropy

Original Poster:

6,441 posts

232 months

Saturday 16th April 2011
quotequote all
Glassman said:
Your Corsa windscreen is glazed directly to the car (bonded). The cured Polyurethane cannot be disturbed or damaged by removing the plastic cowl.

Be sure to check the plastic trim is in place under the bottom of the screen before you offer the cowl back up.
Mate, sure did.

That's why there was a lot of huff & puff. Took a while for me to put that piece of plastic back in. Gotta give to GM for better build quality!