Cup brake bias for beginners

[trap125]

Where would you advise I set my brake bias? I've recently bought a 997.2 Cup (no ABS) and I'm just looking for a basic set up to get me going... Do I just set it to 0 for starters? What percentage does 0 represent front vs rear?

Any advise would be much appreciated. Many thanks.

[Steve Rance]

In the dry, Wind it all the way forward until you start to lock your front wheels and count 3 clicks to the rear from there. In the wet, reverse it. Wind it all the way to the rear until you start to lock your rears and wind 3 clicks forward from there. Intermittent you will have to find a balance that works got you.

That’s your starting point. When you get very good you will start to adapt it

[trap125]

Many thanks again Steve. Ill give that a go...

On a side note I sent you an email via Pistonheads. Did you get it? I was just wondering if the Pistonheads system was working...

[Steve Rance]

It’s the wrong email address. I’ve given up trying to get PistonHeads to change it.

Try [e-mail]

[trap125]

Aaaah! Thanks Steve.

[trap125]

Steve Rance said:

It’s the wrong email address. I’ve given up trying to get PistonHeads to change it.

Try [e-mail]

Hi Steve. I sent you an email a couple of weeks ago... I wondered if you got it? No worries if not or if you don't have time to reply... from [e-mail]

Best wishes,

Ossie