Trickle charger use in winter
Trickle charger use in winter
Author
Discussion

Petershore72

Original Poster:

2 posts

Yesterday (16:59)
quotequote all
Hi all,

This may be a stupid question but here goes!

I've got the mxs 5.0 trickle charger that is plugged into the cigarette socket in the passenger footwell.

At the moment I run the thinner cable from the charger to the cigarette lighter through the passenger door seal which is fine in good weather so the charger sits outside the car (and is plugged into an outdoor socket)

In the winter what do people do to protect the charger (car is outside all year round)

Should I put the charger in the footwell and run the power cable through the door seal (is this possible)?

Or is there a waterproof box available to seal the charger from the elements if left outside the car? Or do you just raise the charger off the ground so it's not in any standing water?

Thanks
Peter

hmg

917 posts

148 months

Yesterday (17:29)
quotequote all
Stick a bucket or a plastic box over it with a brick on top. Or put the charger on top of the wheel
Under the wheel arch.

Super Sonic

14,296 posts

83 months

Yesterday (17:39)
quotequote all
Under the bonnet?

Cheesybit

19 posts

203 months

Yesterday (19:19)
quotequote all
My charger goes in the car and the power cable fits when I close the door, no problem. Was in my OPC a few weeks ago and they did the same thing for their cars on display.

Jones the cat

1,260 posts

21 months

Yesterday (19:29)
quotequote all
Petershore72 said:
Hi all,

This may be a stupid question but here goes!

I've got the mxs 5.0 trickle charger that is plugged into the cigarette socket in the passenger footwell.


Or is there a waterproof box available to seal the charger from the elements if left outside the car? Or do you just raise the charger off the ground so it's not in any standing water?

Thanks
Peter
I think the one to get to outside cars is this one

https://ctek.com/en-uk/products/cs-one-gen-2-uk

It doesn't require a mains feed.
Leave the CS FREE in the passenger footwell
Run its charging leads to the Porsche’s battery/jump-start connection points
Let the CS FREE charge/maintain the battery from there
periodically, once a month, recharge the CS FREE when its internal battery gets low.

No need for any wires going to the car outside.




Petershore72

Original Poster:

2 posts

Yesterday (19:38)
quotequote all
Great thanks all for the helpful suggestions.

I'll probably put the charger in the car and run the mains power cable through the door seal

Jones the cat

1,260 posts

21 months

Yesterday (20:18)
quotequote all
Petershore72 said:
Great thanks all for the helpful suggestions.

I'll probably put the charger in the car and run the mains power cable through the door seal
but you don't need to have any cables outside of the car.

LiamH66

1,104 posts

120 months

Yesterday (22:04)
quotequote all
Jones the cat said:
but you don't need to have any cables outside of the car.
I think you mean this one:

https://ctek.com/en-uk/products/cs-free

You need mains power for the CS One

Jones the cat

1,260 posts

21 months

Yesterday (22:40)
quotequote all
LiamH66 said:
I think you mean this one:

https://ctek.com/en-uk/products/cs-free

You need mains power for the CS One
Thats it! for outdoor cars, thats the one. The One.

lowndes

838 posts

243 months

On a related point, can anyone advise whether the 12v socket in the passenger footwell on 992.1 and/or 992.2 is ignition switched. If either socket is switched is there a defeat sequence to override the ignition switching the 12v socket off as was the case on 991.2.
Thanks.

edc

9,647 posts

280 months

The chargers are IP rated so don't need any particular protection.

jackwood

2,966 posts

237 months

Or just get something like this to put the charger in outside the car.

https://amzn.eu/d/0bR2omUq

Spd6aha

18 posts

135 months

lowndes said:
On a related point, can anyone advise whether the 12v socket in the passenger footwell on 992.1 and/or 992.2 is ignition switched. If either socket is switched is there a defeat sequence to override the ignition switching the 12v socket off as was the case on 991.2.
Thanks.
I've got a 992.1 and bought an OEM trickle charger. If I'm reading your question right, yes you have to 'trick' the socket into being live. Procedure was ignition on, plug charging connector into 12v socket, then plug charger into mains and switch on, then switch ignition off and lock car.
However, this was fidgety and seemed to be intermittent in working. I ended up getting a pig tail connector to the battery, just sits out of frunk trim, and plug into mains (electrician had to changer connector on the charger, easy). However, my car is in a garage so doesn't answer the outside question

Jones the cat

1,260 posts

21 months

jackwood said:
Or just get something like this to put the charger in outside the car.

https://amzn.eu/d/0bR2omUq
Or maybe, just maybe, get the CTEK that requires no external mains cable whatsoever whilst it trickle charges. I repeat, zero mains lead needed.

Magic919

14,499 posts

230 months

Super Sonic said:
Under the bonnet?
This is what I do. Just add the CTEK connectors to the battery on earlier cars, appropriate points on later cars that track charge state.

edc

9,647 posts

280 months

Jones the cat said:
jackwood said:
Or just get something like this to put the charger in outside the car.

https://amzn.eu/d/0bR2omUq
Or maybe, just maybe, get the CTEK that requires no external mains cable whatsoever whilst it trickle charges. I repeat, zero mains lead needed.
But you have to remove and recharge it. On a driveway the cable is a non issue. The units are IP rated and weather proof.

Jones the cat

1,260 posts

21 months

edc said:
But you have to remove and recharge it. On a driveway the cable is a non issue. The units are IP rated and weather proof.
Only once a month and it fully charges in an hour or two. Its a far better solution

elisered

343 posts

111 months

I don’t think the cs free is designed to be used on its own as a long term battery maintainer - unless you link it to a solar kit, the mains or another battery. It’s really more of a booster for a flat or low battery from what I’ve read - so not really useful to the OP?