Lack of boost

[The devil]

Seem to have lost some boost, it only gets to about 0.3 bar andf I have the upgraded 0.7 bar actuators.
Split pipe? actuator? turbo?
It runs fine just got a lack of acceleration

[R0162]

boost leak. Maybe a wastegate is not closing properly?

[hollowpockets]

Check the vacuum hoses are connected to actuators and boost controller, the plug to the boost controller is in and the 90degree piece from the inlet manifold isnt pushed on too far, also check boost hose jubilees are tight and connected then after that start questioning mechanical possibilities like sticky wastegates and throttle position/cable hasn't slipped.

[The devil]

Found the problem, the actuator arm had come off the front turbo,

[Spindoctor]

Glad you found the problem. Was your boost gauge needle fluttering rather than holding steady under boost? That's the symptom I had (other than lack of boost!).

[The devil]

Not really, it would get to 0-3 bar
hopefully a new circlip at the weekend should get it alright again

[Blu3R]

I was going to say that it won't be a split vac hose as you'd get actuator pressure without vac hoses attached to either actuator.