Its been Banished!!
Discussion
A huge thank you to Peter and all at Kerridges who have managed to locate and fix my terrible and constant rattle in the tunnel!!
Best news is that in the process, Peter found a good few other rattles so the car now sounds like a Rolls Royce in the cockpit!! :D
Thanks guys!! :wavey:
Greg Noble.
Best news is that in the process, Peter found a good few other rattles so the car now sounds like a Rolls Royce in the cockpit!! :D
Thanks guys!! :wavey:
Greg Noble.
Mr Noble said:
I left it with (veganT) them for 36 hours.
They really need it overnight to make sure that the saelant has time to set.
One has actually steamed up recently, anyone know how to fix that? I don't think it should happen.
Greg
I had the same problem with one of mine. It is normally caused by the lights not being sealed properly. Looks like you might have to pay another visit to VT. You could get their boost button mod fitted at the same time.

Mr Noble said:
One has actually steamed up recently, anyone know how to fix that? I don't think it should happen.
Greg
Most of them do this Greg. The factory position (unless it has changed)is that that's the way it is!
I've always wondered about adding some venting (more venting, that is as there clearly is already some!) and a small heating element underneath the pod but its all too Heath Robinson and complicated I suppose!
I must say there was a Lambo out on a Norhtans run once and it had a misted up rear light - that made me feel better

AMG Merc said:
Most of them do this Greg. The factory position (unless it has changed)is that that's the way it is!
He's talking about the Afterburners.
AMG Merc said:
I've always wondered about adding some venting (more venting, that is as there clearly is already some!) and a small heating element underneath the pod but its all too Heath Robinson and complicated I suppose!
I must say there was a Lambo out on a Norhtans run once and it had a misted up rear light - that made me feel better
Headlights right? Well here's an interesting thing. One of mine misted up from day one. After a while Roush found a tiny hole in the sealent (on the outside next to the bodywork), and dried it out as best they could.
Still misted. In the end the spray shop took the whole light out. It had about 1/2 inch of water in it! But, you couldn't see it as the inner painted part of the light hid it.
So, you MUST take the whole light off when drying it. Ever since I've not had and issue.
Gassing Station | Noble | Top of Page | What's New | My Stuff



