Pre track day checks?
Discussion
Dear All,
Please don't take the above as a concise & complete list and its in no particular order but it should make a good starting point/guide should you wish to give the car a once over yourself before venturing out on track.
Best Regards
Matt
FP said:
Pre Track Use Check List (Noble M12 All Models) - 04/07/2005
-Engine Oil Level
-Power Steering Fluid Level
-Engine Coolant Level
-Fuel Level
-Rad Fan Activation
-Brake Fluid Level
-Visual Inspection For Fluid Leaks, Oil/Coolant/PS Fluid/Brake Fluid (at master cyl and calipers)
-Visual Inspection Front/Rear Brake Pad and Disc Condition.
-Spanner Check Front/Rear Suspension
-Visual Inspection Front/Rear springs/dampers
-Spanner Check On Front/Rear Hub Nuts (if loose replace)
-Visual Inspection General Condition of Front/Rear Wheels and tyres.
-Visual Inspection Exhaust Mountings and Supports
-Visual Inspection Exhaust Manifold condition and Turbo Gaskets Condition
-Visual Inspection CV Boots
-Visual Inspection Coolant/Boost Hoses
-Visual Inspection 5SP/Non-M400 Gearchange Cable Security/Proximity to Water Pump Pulley.
-Visual Inspection Throttle Cable Condition/Security/Proximity to front bank turbo.
-Torque wheel nuts/bolts to Noble Spec.
-Lights, Indicators, Brake Lights etc.
-Visual Inspection Harness Mountings and Condition.
-Tyre Pressures
Please don't take the above as a concise & complete list and its in no particular order but it should make a good starting point/guide should you wish to give the car a once over yourself before venturing out on track.
Best Regards
Matt
matt_fp said:
Dear All,
FP said:
Pre Track Use Check List (Noble M12 All Models) - 04/07/2005
-Engine Oil Level
-Power Steering Fluid Level
-Engine Coolant Level
-Fuel Level
-Rad Fan Activation
-Brake Fluid Level
-Visual Inspection For Fluid Leaks, Oil/Coolant/PS Fluid/Brake Fluid (at master cyl and calipers)
-Visual Inspection Front/Rear Brake Pad and Disc Condition.
-Spanner Check Front/Rear Suspension
-Visual Inspection Front/Rear springs/dampers
-Spanner Check On Front/Rear Hub Nuts (if loose replace)
-Visual Inspection General Condition of Front/Rear Wheels and tyres.
-Visual Inspection Exhaust Mountings and Supports
-Visual Inspection Exhaust Manifold condition and Turbo Gaskets Condition
-Visual Inspection CV Boots
-Visual Inspection Coolant/Boost Hoses
-Visual Inspection 5SP/Non-M400 Gearchange Cable Security/Proximity to Water Pump Pulley.
-Visual Inspection Throttle Cable Condition/Security/Proximity to front bank turbo.
-Torque wheel nuts/bolts to Noble Spec.
-Lights, Indicators, Brake Lights etc.
-Visual Inspection Harness Mountings and Condition.
-Tyre Pressures
Please don't take the above as a concise & complete list and its in no particular order but it should make a good starting point/guide should you wish to give the car a once over yourself before venturing out on track.
Best Regards
Matt
Matt, out of interest how do you check that the rad fans are operating?
m12_nathan said:
Open the front clam and run the engine until the fans switch on?
Hmmm, I was hoping for a more scientific and faster method than than Nathan!
Something like I had on an old TVR - I wired a switch under the dash that bypassed the sensor to keep the engine cooler when I was queueing at racetracks!
I'm aware of the various methods of forcing the fans into operation as a check (and kindly mentioned by my Nobility bretheren above!) - the point of my question was I was wondering whether the "experts" had a fast method of checking these fast without running up the engine to hot (eg: by way of hotwiring) - clearly not!
Gassing Station | Noble | Top of Page | What's New | My Stuff





And you get to have a drive too