Gutted!!
Author
Discussion

p1carl

Original Poster:

635 posts

265 months

Thursday 19th October 2006
quotequote all

AMG Merc

11,955 posts

282 months

Thursday 19th October 2006
quotequote all
OUCH! How - a funny damage angle?!

Looks like the diffuser is OK so won't need removing - just the clam?

LJM

241 posts

249 months

Thursday 19th October 2006
quotequote all
Ouch, not very nice at all. How did that happen? Gutted for you.

mgbond

6,749 posts

261 months

Thursday 19th October 2006
quotequote all
LJM said:
Ouch, not very nice at all. How did that happen? Gutted for you.


Last weekend I went down a massive pot hole while turning in a layby I smashed the diffuser but nowhere near as expensive as that will be. Hope it was a no fault insurance job.

Bondy

p1carl

Original Poster:

635 posts

265 months

Thursday 19th October 2006
quotequote all
I'd like to say someone run into me but they didn't, I reversed into a Ford Escort at the petrol station mad One sec it was clear the next it wasn't eek I was hardly moving - anywhere else on the clam but there, wouldn't have been so much of an issue I guess!!

hunttheshunt

1,093 posts

269 months

Thursday 19th October 2006
quotequote all
I think I may weeping

hunttheshunt

1,093 posts

269 months

Thursday 19th October 2006
quotequote all
Still every cloud has a silver lining, get the front blown in at the same time!

LJM

241 posts

249 months

Thursday 19th October 2006
quotequote all
I wouldn't worry too much about it, a good bodyshop should be able too re-shape it and get it looking like new for not too much money!! Hope that makes you feel a bit better anyway!!

mr noble

6,538 posts

262 months

Thursday 19th October 2006
quotequote all
Sorry to seee thet mate! Turns your stomach!

Don't wish to put any downers out but I think that could be a big problem as its the pivot point. When my clam was smashed, I was told that it was irrepairable due the the pivot point being smashed off.

They can do wonders with the stuff though, and its not totally gone. (ie, the hole point is still in correct location.)

Not sure where in the country you are, but try Sinclair's. They are normally on hand at Bedford trackdays and are supposed to be able to work magic with elise clams.

Greg

paulcundy

1,897 posts

294 months

Thursday 19th October 2006
quotequote all
LJM said:
I wouldn't worry too much about it, a good bodyshop should be able too re-shape it and get it looking like new for not too much money!! Hope that makes you feel a bit better anyway!!


gaffer tape mate - no worries.

adrian w

15,458 posts

257 months

Friday 20th October 2006
quotequote all
I know it's a long way to come, Roush have a tame bodyshop with experience of re-building broken clams.

p1carl

Original Poster:

635 posts

265 months

Friday 20th October 2006
quotequote all
Thanks for the kind words guys. I could do with the contact numbers for Sinclair's and Roush (is that how you spell it?).
Noble approved body shop reckon 9K yikes I'm just staggered!

ThatPhilBrettGuy

11,810 posts

269 months

Friday 20th October 2006
quotequote all
p1carl said:
Noble approved body shop reckon 9K yikes I'm just staggered!
That's stupid. I punched a 2 inch square hole in the rear clam and ripped the spoiler off pulling a good 3 inches with it. Less than £1000 and you can't see the damage at all.

Someone else here did much worse than yours in the same lower bracket area and that wasn't much either. Roush are on 01277 261400

r5gttgaz

7,897 posts

249 months

Friday 20th October 2006
quotequote all
p1carl said:
Thanks for the kind words guys. I could do with the contact numbers for Sinclair's and Roush (is that how you spell it?).
Noble approved body shop reckon 9K yikes I'm just staggered!


Carl, take it to MSM in Winterton, they will do a sterling job, speak to Steve and tell him that Gaz with the 5 turbo and silver M3 sent you.

joust

14,622 posts

288 months

Friday 20th October 2006
quotequote all
p1carl said:
Thanks for the kind words guys. I could do with the contact numbers for Sinclair's and Roush (is that how you spell it?).
Noble approved body shop reckon 9K yikes I'm just staggered!
It'll be that for a new clam and match.

As people say, there are plenty of 'handy' GRP specalists that will do that for a fraction of the cost.

J

paulcundy

1,897 posts

294 months

Friday 20th October 2006
quotequote all
Ring Plans, they use a body shop called 355 who are magicians. They'll have it disparu in a jiffy and no stupid london labour rates.
Regards
Paul C

Rish

66 posts

249 months

Friday 20th October 2006
quotequote all
Hi, Im new here and have been a lurker for quite a while... read

That looks bad, but give the MSM guy at Winterton a call, he is good.
Alternatively, know a decent chap in Sheffield, Dovedale motors.

AMG Merc

11,955 posts

282 months

Friday 20th October 2006
quotequote all
joust said:
It'll be that for a new clam and match. J


If a rear clam is £3.5K what's the other £5.5K for then?!


Monday 25th April 2005
--------------------------------------------------------------------------------
Front clam, primed/unpainted: £1931.99 + VAT
Rear clam, primed/unpainted: £2962.49 + VAT

Simon Hucknall
Press Officer
Noble Automotive Ltd.

joust

14,622 posts

288 months

Saturday 21st October 2006
quotequote all
AMG Merc said:
If a rear clam is £3.5K what's the other £5.5K for then?!
Paint, fit, and blend in back of car I'd imagine.

With the Elise (simple split) it was £5000 when the clam costs £1100. I just let the insurance company pay it.

J

p1carl

Original Poster:

635 posts

265 months

Saturday 21st October 2006
quotequote all
AMG Merc said:
joust said:
It'll be that for a new clam and match. J


If a rear clam is £3.5K what's the other £5.5K for then?!


Monday 25th April 2005
--------------------------------------------------------------------------------
Front clam, primed/unpainted: £1931.99 + VAT
Rear clam, primed/unpainted: £2962.49 + VAT

Simon Hucknall
Press Officer
Noble Automotive Ltd.


Clam £3,258
Difuser £216
Lab to remove and strip old clam and refit to new clam and make fit £1480
Labour to paint and polish £1480
Panint and materials £750
badges, mesh, padding, heat shields make up the rest
Then good old VAT!