Discussion
You could always get them re-trimmed by Auto Interiors, they did the leather work on the early Nobles built in the UK and then were involved in training the factory in South Africa.
Contact Martyn:
http://www.auto-interiors.net/index.htm
I got a different colour handbrake and gear gaiter from him a few months ago, when I was there he said that he would be happy to do repair or re trim work directly if needed. He also does Noble headrests and mats.
Eddie
Contact Martyn:
http://www.auto-interiors.net/index.htm
I got a different colour handbrake and gear gaiter from him a few months ago, when I was there he said that he would be happy to do repair or re trim work directly if needed. He also does Noble headrests and mats.
Eddie
Change of plan, I am having my existing seats re-upholstered here in Wokingham. Replacing cream leather with black alcantera with slightly different stitching and lots more padding. Also having a decent amount built into the head support, so that it actually does something. I'll post the results when I get them back.
MadMacMcMad said:
Change of plan, I am having my existing seats re-upholstered here in Wokingham. Replacing cream leather with black alcantera with slightly different stitching and lots more padding. Also having a decent amount built into the head support, so that it actually does something. I'll post the results when I get them back.
just bought a set of sparco milano 2 recliner seats as my girlfriend carnt stand the originals .come to think of it neither can i .if the recliners fit they will be stripped down and treated to cream and blue leather as my es cossie
Biggriff said:
Keep us informed as this is one mod I want to do. Hate the standard seats.
Got the seats in.They do hit the rollbar ,but can be sorted when i get them leathered ,also the seat bottoms are to flat so i can either wedge the fronts or pad the front when they come out again.If i was going to do this again the seats i would get would be the konig recliners as used on the golf r32 as these are thiner and not as tallBiggriff said:
Keep us informed as this is one mod I want to do. Hate the standard seats.
hi richard changing the seats is a bit of a mare 1 the base of the seats are to wide and siit on top of the strenghtening bars
2 They sit to flat to the floor
3 The reclining knobs foul the tunnel
4The top wing on the seats hit the roll bar
1 and 2 .ive made a set of sliders that lift the seat clear and also a 3inch angle to push you back in them.Down side was you sit to high but made 2 brackets at the base to lower and angle the base cushion
3 had to remove one side of the reclining knobs and cut 2 inchs off the through bar ,but will be covered when leathered
4 removed fabric from top wing and adjusted the framework very slightly
down side is the weight of the seats and make rear quarter view difficult
Took the car for a 60 mile run with the drivers seat in place and i must say bloody comfy as
Gassing Station | Noble | Top of Page | What's New | My Stuff


