Temperature Gauge
Temperature Gauge
Author
Discussion

JAZ 34

Original Poster:

568 posts

272 months

Sunday 4th November 2007
quotequote all
Hello guys,

Noticed today that after I took the car for a spin I let it idle in the drive. Noticed the temperature guage on the dash all over the place. The needle movement was very quick from side to side. Would it be a sensor problem or something like that?

Anything to worry about?

Thanks,

JAZ 34

F.C.

3,901 posts

237 months

Sunday 4th November 2007
quotequote all
JAZ 34 said:
Hello guys,

Noticed today that after I took the car for a spin I let it idle in the drive. Noticed the temperature guage on the dash all over the place. The needle movement was very quick from side to side. Would it be a sensor problem or something like that?

Anything to worry about?

Thanks,

JAZ 34
The temperature signal to the guage is generated by the cars ECU.
Better to get it checked out sooner rather than later.
F.C.

mgbond

6,749 posts

261 months

Sunday 4th November 2007
quotequote all
...The temperature signal to the guage is generated by the cars ECU.
Better to get it checked out sooner rather than later.
F.C.....

Unless its a 2.5!

Bondy

peterguk

2,622 posts

246 months

Sunday 4th November 2007
quotequote all
Does it not depend on which ECU?

Naso Grande

237 posts

228 months

Sunday 4th November 2007
quotequote all
Sounds like an intermittent connection on the temp sensor. I think that there is a failsafe built in to the ECU(MBE) that in the event of a failure in the temp sensor or connecting wires then it goes full scale to protect the engine (I think, please correct me if I'm wrong). If you have the Noble diagnostics software then you can check what the ECU is reading from the sensor.

HTH,
Graeme

ps What's a 'guage'?teacher

F.C.

3,901 posts

237 months

Sunday 4th November 2007
quotequote all
Naso Grande said:
Sounds like an intermittent connection on the temp sensor. I think that there is a failsafe built in to the ECU(MBE) that in the event of a failure in the temp sensor or connecting wires then it goes full scale to protect the engine (I think, please correct me if I'm wrong). If you have the Noble diagnostics software then you can check what the ECU is reading from the sensor.

HTH,
Graeme

ps What's a 'guage'?teacher
It's a rubbish keybaord hehe
F.C.