Pro Alloy measurement needed.
Discussion
daddysumo said:
Can someone with the Pro Alloy I/C and hard pipe kit fitted please measure from the rear face of the I/C to the back edge of the air box/frame work as mine has previously been modified so the fitting instructions don't help much !
Will have a measure tomorrow for you and give you a shout if you still need it?Twerlie said:
daddysumo said:
Can someone with the Pro Alloy I/C and hard pipe kit fitted please measure from the rear face of the I/C to the back edge of the air box/frame work as mine has previously been modified so the fitting instructions don't help much !
Will have a measure tomorrow for you and give you a shout if you still need it?
Yes Please ! Thanks Ross. (seem to have lost your mob No)
Steve
daddysumo said:
Twerlie said:
daddysumo said:
Can someone with the Pro Alloy I/C and hard pipe kit fitted please measure from the rear face of the I/C to the back edge of the air box/frame work as mine has previously been modified so the fitting instructions don't help much !
Will have a measure tomorrow for you and give you a shout if you still need it?Steve
Twerlie said:
daddysumo said:
Twerlie said:
daddysumo said:
Can someone with the Pro Alloy I/C and hard pipe kit fitted please measure from the rear face of the I/C to the back edge of the air box/frame work as mine has previously been modified so the fitting instructions don't help much !
Will have a measure tomorrow for you and give you a shout if you still need it?
Yes Please ! Thanks Ross. (seem to have lost your mob No)
Steve
I make it 82mm. This was taken from the rear base of the i.c. to the edge of the box/framework. I hope that is what you were after?
Thanks Ross.
That's to the rear edge ? Will mark it up tomorrow !
Steve
on a side note - i have just fitted one of thier uprated radiators
its a quality bit of kit that puts the stock radiator to shame
i have not done many miles with it fitted yet - buy already the temps are significantly reduced
there are some nice touches like the aircon rad is held in place with proper cap head bolts instead of self tappers !
the welding is good quality
removal / fitting was not an easy job - Noble fit the radiator / aircon rad and oil cooler as one assembly and then connect them up - trying to remove it means the bolts are covered by the chassis !!
grr
all in its a quality bit of kit and reasonably priced for the quality
its a quality bit of kit that puts the stock radiator to shame
i have not done many miles with it fitted yet - buy already the temps are significantly reduced
there are some nice touches like the aircon rad is held in place with proper cap head bolts instead of self tappers !
the welding is good quality
removal / fitting was not an easy job - Noble fit the radiator / aircon rad and oil cooler as one assembly and then connect them up - trying to remove it means the bolts are covered by the chassis !!
grr
all in its a quality bit of kit and reasonably priced for the quality
Gassing Station | Noble | Top of Page | What's New | My Stuff