Starter motor feed fuse/relay location?

[joust]

Starter motor won't turn over on the M400. Checked the feed to the solenoid and it's missing 12V. I'm assuming it's either the fuse or the relay, but I can't remember where they are on the M400. Are they on the rear bulkhead above the ECU?

Any ideas? Do I have to take the wheel and wheel arch liner out to get to them if they are on the bulkhead?

Thanks,

J

[Rob_W]

Yes they are beside the ECU, not sure which fuse but relay should be second from left (as you look from the back of the car). You can reach them without removing anything with a little agility but easiest way is to start with removing the front turbo rubber pipe section and reach down rather than going to the trouble of removing the wheel and arch liner.

[joust]

All done. Thanks. Second one down on the fuses had blow - guess it was just so cold this morning that the starter wouldn't turn!

J