Roush gaskets?

[swampy56]

Where can I get some 65mm inside diameter 3 bolt gaskets from? Most places stock the 60mm not the 65mm.
Thanks Paul

[RobP]

most motor factors. If they don't have them in stock, usually only takes a couple of hours to get them.

[Jim O.]

I don't know if you can find them over there, but the three-bolt exhaust gaskets made out of soft copper seem to work very well for us, and last a long, long time. I guess if you were feeling industrious, you could buy a piece of copper sheet and cut out the gaskets that you need...

[swampy56]

Havn't seen those for years! You use to be able to get head gaskets made in copper and re-use them. might be a bit pricy now copper is at an all time high. Will try some other motorfactors
Thanks guys
Paul

[tonyvan]

they are from piper exhausts !!!!

[Rob_W]

I tried Piper and they were helpful but couldn't supply, eventually found on ebay from seller racingxs

[2.5bluenob]

Rob_W said:

I tried Piper and they were helpful but couldn't supply

Why's that?

[Rob_W]

2.5bluenob said:

Why's that?

They could supply ones for 2 1/4" pipes (60mm) but couldn't find any of the larger 2 1/2" (65mm), we exchanged a couple of phone calls and even faxed images of what I was after and they tried to resolve but nothing doing so good effort but no result.

[Rob_W]

Maybe I should add that of the three joints I've taken apart only one had a gasket fitted so whether they are worth it I don't know!!!

[5paulmv]

iff i remember right you can modify the gasket of a 1998 transit van its the first one after the manifold cost about 2 quid at the local motor factors take your old one in to lay over it