2004 Honda S2000 GT
Author
Discussion

Theprancingdonkey

Original Poster:

2 posts

1 month

peter2reed

4 posts

24 months

Wednesday 24th June
quotequote all
Hi any work done on the brake lines at any point please?

Theprancingdonkey

Original Poster:

2 posts

1 month

Wednesday 24th June
quotequote all
Hi, Not to my knowledge. If you are referencing the MOT I believe this means that the lines are covered by paneling.

swissheavy

4 posts

191 months

Tuesday 30th June
quotequote all
When were the valve clearances last checked/adjusted? If you can shoe the invoice that would be good

When was it last aligned? Again invoice for that, I’d want to see front camber and castor adjustments super important for the chassis.

I would also like to see a start up from cold and listen to the engine and then see the exhaust.

Also, what’s the underbody condition like particularly the sub frames?

Theprancingdonkey

Original Poster:

2 posts

1 month

Wednesday
quotequote all
swissheavy said:
When were the valve clearances last checked/adjusted? If you can shoe the invoice that would be good

When was it last aligned? Again invoice for that, I d want to see front camber and castor adjustments super important for the chassis.

I would also like to see a start up from cold and listen to the engine and then see the exhaust.

Also, what s the underbody condition like particularly the sub frames?
We haven't had this done as this has only done ≈9,000 miles in our ownership

Again this car has only done ≈9,000 in our ownership we haven't had cause to carry out alignment checks as it has always driven fine. It has been used as a Sunday driver and not driven hard.

Your are more than welcome to come and view cold start up for yourself.

There are multiple photos of the under body and sub frame in the listing.

Jason-tw7q7

3 posts

112 months

Wednesday
quotequote all
Hi. Is there any rust on the rear arches? Does the car still have the rubber arch strips on the rear as these hide a lot of corrosion. Many thanks.