Electronic oil gauge
Electronic oil gauge
Author
Discussion

cay

Original Poster:

380 posts

187 months

Thursday 18th August 2011
quotequote all
Is it normal for the electronic dipstick to be a bit variable?

I've done 5k miles in my car and only added around 250ml of oil, I added the oil when the gauge was consistently reading one blob down from the maximum mark.

After adding the oil it went up to the maximum mark as I expected.

Checking the oil recently though I notice sometimes it reads maximum, sometimes it reads over maximum ( all blobs full ) and sometimes it reads one blob down as if I need to top the oil up.

I thought the built in timer was supposed to ensure the reading was consistent, yet it still seems to vary.

I wonder if I have a faulty sensor?

nsm3

2,831 posts

227 months

Thursday 18th August 2011
quotequote all
I wouldn't put any oil in until it is one block above minimum (provided oil pressure readings normal and no warning light).

Those electronic gauges go up and down like a Brides nightie, so there is a danger of overfilling, which can causes more problems than running near minimum?

R Soul

123 posts

196 months

Thursday 18th August 2011
quotequote all
Mine only varies with the road camber, i.e. the reading seems fairly consistent in itself but that reading depends on how level the surface is that the car is parked on.

Parked on a slight slope, or both the road wheels of one side of the car parked on a kerb can either show that the oil level is at its minimum, or maximum - depending on how level the car is parked.

I'd be surprised if the oil level varies up and down if you check it whilst the car is parked in the same place.

monthefish

20,467 posts

262 months

Thursday 18th August 2011
quotequote all
nsm3 said:
I wouldn't put any oil in until it is one block above minimum (provided oil pressure readings normal and no warning light).

Those electronic gauges go up and down like a Brides nightie, so there is a danger of overfilling, which can causes more problems than running near minimum?
I do similar, although I tend to keep mine 2 bars below maximum. Check it after most drives, and if it has dropped to 3 bars below maximum, I add a bit of oil. That way there's a comfortable 'tolerance' for both the reading of the gauge and my skill in adding measured amounts of oil.



For the same tolerance reason, I'd be a bit concerned about keeping it at one block above minimum however - is that not a bit risky?

RudeDog

1,670 posts

205 months

Thursday 18th August 2011
quotequote all
Is there not a built in tolerance with the gauge also? So even if its on bottom or top, there is still a safety margin.

To the OP, mine is very inconsistent also, I just make sure I check it regularly and top it up in small amounts whenever necessary. (Cayman S)

gsewell

724 posts

314 months

Thursday 18th August 2011
quotequote all
So you are suggesting to wait until there are 2 empty blocks on the e-dipstick. How much would you then suggest to add? 400ml to get it back in the middle or 800ml to get to the top?

cay

Original Poster:

380 posts

187 months

Thursday 18th August 2011
quotequote all
Thanks for all the replies.

I think I will wait until it drops a couple of bars before adding oil.

Hopefully I haven't overfilled, I only added a small amount of oil and afterwards it was back up to the maximum mark so should be fine.

monthefish

20,467 posts

262 months

Monday 22nd August 2011
quotequote all
Just found this on another forum:

someone on another forum said:
Each bar is .25 liters. The car display shows up to full plus one bar (.25 liters more than full). If you are just teetering between full and just over full, you are not in real danger. A few more miles and you'll be fine.
Don't know if it's tru, but the bit in bold is quite interesting (and makes sense I suppose)