Steering wheel shakes when braking
Steering wheel shakes when braking
Author
Discussion

Johno255

Original Poster:

22 posts

188 months

Sunday 21st August 2011
quotequote all
Had a service done about a month ago along with a brake fluid change on my 911 996 Turbo. For some reason over the last couple of days the steering wheel has started to shake when braking both hard and softly. Tyres and tracking done about 2 months ago so don't think it would be that. Any ideas? Cheers

SaucyBoy

1,865 posts

260 months

Sunday 21st August 2011
quotequote all
Not an expert by any stretch of the imagination but sounds like you may have a high spot on your disc/discs?? Also known as warped. Do you wash the car a lot and then leave it standing so the brakes bind?

I had the above on my last car and it was a high spot on the inside of one of the discs. I looked into getting the discs skimmed but opted for new discs as they were getting on.

I'm sure some one more technically minded and experienced will come along to give some advice shortly.

UVB

557 posts

224 months

Sunday 21st August 2011
quotequote all
Does sound like discs. As they get worn, they are more prone to warping through heat (worn discs are thinner obviously, so they warp easier).

Trev450

6,775 posts

203 months

Sunday 21st August 2011
quotequote all
I had the same problem with my Cayman S and was diagnosed with warped discs at the last service.

anonymous-user

85 months

Sunday 21st August 2011
quotequote all
UVB said:
Does sound like discs. As they get worn, they are more prone to warping through heat (worn discs are thinner obviously, so they warp easier).
Not true. Bulk of overall thickness is in cooling webs etc, wearing surface is not that thick and has little effect on warping potential.

In any case, as said earlier, more likely to be uneven surface caused by corrosion. True warping rarely happens.

boxsey

3,579 posts

241 months

Sunday 21st August 2011
quotequote all
It's always worth checking the basics, so check that your wheel bolts are torqued up correctly (130 nm), especially if you've removed a wheel or two recently.

dazren

22,612 posts

292 months

Sunday 21st August 2011
quotequote all
Had a similar problem with my car last year. The Control arm bushes needed replacing.

Stevorocket

408 posts

250 months

Sunday 21st August 2011
quotequote all
Sounds wrong but I had bad steering judder that felt like brake disks on a Euro trip - it was wheel balance.

MADT350

394 posts

242 months

Sunday 21st August 2011
quotequote all
Beg to difffer with some comments defo your front discs, new car , 2.500 miles , discs warped, not sure how? Got new discs under warranty. Porsche discs are sub standard lots of comments on the inter web.....never had any issues with discs my Aston....

graemel

7,230 posts

248 months

Sunday 21st August 2011
quotequote all
Has to be warped discs. On air head cars OE discs only for me. My 3.6 turbo warped diss all the time. Three sets. Siezed calipers on one side. A low mileage car. New calipers, big reds solved the issue.