flat battery jumpstart & now one touch windows don't work...
flat battery jumpstart & now one touch windows don't work...
Author
Discussion

philcray

Original Poster:

866 posts

234 months

Wednesday 7th September 2011
quotequote all
Not used the car (2007 997 c2s) for a few weeks what with holidays and all that. Came to start it yesterday and the battery was almost completely flat.

Slightly off this topic but in line with another recent post, the car was unlocked when i initially went into the garage and the bonnet had popped up. I may have forgotten to lock it and accidently opened the bonnet before I went on hols, but it seems very unlikely - and there are quite a number of other occasions when I have found the bonnet opened so this does seem to be a fault rather than a user error?

Back to the flat battery, I checked the owners manual and then jump started it. The drivers side window had automatically lowered itself about half way(?) and the manual mentioned about closing it once, then pressing the up rocker switch again to reset the window memory. I did this and all seemed ok so I went for a drive, on returning I noticed that the one touch feature to close the windows does not now work (however one touch works when opening).

Any thoughts please?

Durzel

13,029 posts

199 months

Wednesday 7th September 2011
quotequote all
Not the same car but on my Type-R when the battery is discharged and the car restarted the one-touch window rollup has to be "trained" to know how high to go up and down by manually using the window control to make it go up, still holding it down for a couple of seconds once it has been stopped by the frame, then letting go. After that one-touch works.

It wouldn't surprise me if a Porsche uses broadly the same system.

mankey

654 posts

234 months

Wednesday 7th September 2011
quotequote all
Here you go. Excerpt from the manual .....

1 Close the window with the rocker switch ONCE

2 Press the rocker switch upwards again to store the end position of the window in the control unit.

bobsan

495 posts

250 months

Wednesday 7th September 2011
quotequote all
no need to re-train windows after flat battery.

when battery is flat or removed and then then charged or reconnected the ecu reverts back to its basic settings.

if the option box for window control was ticked to auto open on press, that particular option wont be seen first time battery is connected.

the ecu will load that setting in next time vehicle ignition is switched on.

fuel maps will also be set back to factory setting and not learn what type of fuel (RON value) is being used for several miles.

philcray

Original Poster:

866 posts

234 months

Friday 9th September 2011
quotequote all
Thanks for the feedback, I had tried the "training" of the windows when I first restarted the car but it did not seem to work. However, as mentioned above, they have reset themselves (as has the satnav which went a bit doolally for the first few miles and did not know where it was) when I drove the car today so everything seems to be back to normal.

Cheers

Phil