964 wheel options.
964 wheel options.
Author
Discussion

Steve Devaney

Original Poster:

719 posts

233 months

Tuesday 20th September 2011
quotequote all
Will a 17'' 255 wheel fit in my std C2 964 rear arch?

Looking at Cup 1 alloys but not sure if 255 is too wide as the std D90 rear wheel is 225.

Sizes are 205 50 ZR17 on the front and 255 40 ZR17 on the rear

Regards,

Edited by Steve Devaney on Tuesday 20th September 10:32

Slippydiff

16,502 posts

254 months

Tuesday 20th September 2011
quotequote all
Should be absolutely fine if you stick with sensible ride heights and ET numbers (rears should be ET55) you may even want to run spacers on the rear to fill the arches out a bit more convincingly.

Steve Devaney

Original Poster:

719 posts

233 months

Tuesday 20th September 2011
quotequote all
Slippydiff said:
Should be absolutely fine if you stick with sensible ride heights and ET numbers (rears should be ET55) you may even want to run spacers on the rear to fill the arches out a bit more convincingly.
I am running bilsteins at approx -30mm. Should this be ok?






Edited by Steve Devaney on Tuesday 20th September 12:01

Lemass

91 posts

183 months

Tuesday 20th September 2011
quotequote all
I have 255/40's on cup 1's
Just lowered it 40mm and on spirited drives it catches all round on heavy bumps, only a little bit though not massive.
i'll roll the arches when i repaint it though as ill be swapping to veloce 18"'s