Milltek design and fitment question 996tt
Discussion
fitted a Milltek exhaust today which is different from the Tubi and Design tek I have seen as there are 2 separate back boxes but once they are both fitted they connect together using large ring which sits inside the join and then a clamp is fitted over the top of the join, the clamp is tightened up and untill it seals the join.
I am not sure if I have been sent the wrong size ring but the fit did not seem great and the exhaust blew a little at the join, I used some exhaust sealant and really tightened it up and all seems fine but I am not sure about the design.
anyone else think this? surely there is a better way to join the 2 Exhausts?
I am wondering if I was meant to joint the 2 Exhausts off of the car and then fit as one item instead of 2? can anyone with experience comment.
on the plus side it sounds great, very stock but louder and a bit more aggressive
cheers
Lee
I am not sure if I have been sent the wrong size ring but the fit did not seem great and the exhaust blew a little at the join, I used some exhaust sealant and really tightened it up and all seems fine but I am not sure about the design.
anyone else think this? surely there is a better way to join the 2 Exhausts?
I am wondering if I was meant to joint the 2 Exhausts off of the car and then fit as one item instead of 2? can anyone with experience comment.
on the plus side it sounds great, very stock but louder and a bit more aggressive
cheers
Lee
topjay said:
thanks for that Topjay!Gassing Station | Porsche General | Top of Page | What's New | My Stuff