993 varioram bhp
Discussion
Porsches have a tendency to produce at least the specified output, so if evrything is working correctly expect closer to 300bhp.
When racing we have to have standard engines (in every respect) but there is a 5% tolerance added for an absolute 'legal' limit. Most cars tested are just within this upper limit. I had mine tested before the start of the season, should be 204bhp = 150kW. It came in around 158.5kW so the timing was adjusted to get it within limits 156.5kW. The engine was built at the start of the previous year so was not too fresh, nor too worn. It got taken for power testing after Silverstone (Britacr weekend) and was found to be 154.5kW, although the figure pre-loss-adjustment was almost identical to the start of the season so even after a long season (16 races up to that point) it was still producing pretty much the same as at the start.
When racing we have to have standard engines (in every respect) but there is a 5% tolerance added for an absolute 'legal' limit. Most cars tested are just within this upper limit. I had mine tested before the start of the season, should be 204bhp = 150kW. It came in around 158.5kW so the timing was adjusted to get it within limits 156.5kW. The engine was built at the start of the previous year so was not too fresh, nor too worn. It got taken for power testing after Silverstone (Britacr weekend) and was found to be 154.5kW, although the figure pre-loss-adjustment was almost identical to the start of the season so even after a long season (16 races up to that point) it was still producing pretty much the same as at the start.
Agree close to 285 is the norm on a vram, don't know where this idea of 300bhp comes from on standard spec car,,,993's are not known for being excessive with their bhp.
There are a couple of v/ram rubber connections that collapse with age in the system, these are likely to have a negative effect on the torque curve,,,cost literally a few £ to source parts from OPC.
There are a couple of v/ram rubber connections that collapse with age in the system, these are likely to have a negative effect on the torque curve,,,cost literally a few £ to source parts from OPC.
Gassing Station | Porsche General | Top of Page | What's New | My Stuff



