Rear Bumper Removal
Discussion
toby tucker said:
how easy is to remove the rear bumper as a DIY proposition?
I'm going try and replace the exhaust/turbo heat shields myself - OPC quote of £700+ is taking the pi$$.
Toby, r u sure this shield needs replaced, they never really rust as I mentioned before.I'm going try and replace the exhaust/turbo heat shields myself - OPC quote of £700+ is taking the pi$$.
You best leave it and wait till you get a plug service, honestly!
I have just done mine, as I was doing plug change, but if you were to do it I would recommend you change plugs also at sametime, It does no harm! Would take you 4-5hrs tops (for a DIY Newbie)
I would wait but if your thinking of doing it send me a pm.
Thx for the feedback guys.
I had my local garage put it up on their ramps today to take a look for myself.
The turbo heat shields are definately past their best & could do with replacement now - however the exhaust heat shields are fine & should last for a while.
The job itself doesn't look as if it needs any specialist skills - easiest route looks to be disconnecting the whole exhaust/manifold assembly from the engine which looks straightforward - except that there's some additional plumbing work that would need to be disconnected before the assembly can be extracted from the rear of the car. Also there's 8 bolts attaching the rear exhaust box to the turbo manifolds that are past their best and will need to burned off with an oxy-act torch which is beyond my skill set - now where's my nearest kwik fit dealer ?!!
I had my local garage put it up on their ramps today to take a look for myself.
The turbo heat shields are definately past their best & could do with replacement now - however the exhaust heat shields are fine & should last for a while.
The job itself doesn't look as if it needs any specialist skills - easiest route looks to be disconnecting the whole exhaust/manifold assembly from the engine which looks straightforward - except that there's some additional plumbing work that would need to be disconnected before the assembly can be extracted from the rear of the car. Also there's 8 bolts attaching the rear exhaust box to the turbo manifolds that are past their best and will need to burned off with an oxy-act torch which is beyond my skill set - now where's my nearest kwik fit dealer ?!!

Edited by toby tucker on Monday 8th October 20:00
Gassing Station | Porsche General | Top of Page | What's New | My Stuff


